Gazer F525 [5/52] Important information

• Do not insert or remove the SD card when the device is

connected to a power supply or working with an external power

unit. This can lead to the MVR malfunction. Wait for 30 seconds

after the MVR shutdown, make sure that all the lights are off for

at least 10 seconds, and only then safely remove the memory

card.

• Set the correct time and date before using the device. The MVR

may not record in case these settings were entered incorrectly.

• Use at least 0.5 seconds time interval while pressing control

buttons, otherwise you may need to remove the battery from

the device in order to reboot the system.

• Carefully connect the power supply cable to the device. MVR

power supply cable should not be confused with the radar

detector or navigator power supply cables (those may have

voltage of +12V). A wrong connection may cause MVR failure.

• Do not turn off the power for at least 20 seconds after the

power supply cable is connected. This is necessary to help the

built-in battery function correctly.

• If after you have started the car (when the power supply cable

is connected to the MVR), the device failed to switch to the

recording mode automatically, simply unplug the power supply

cable for ten seconds and then try again.

• Use the restart option (by removing the battery from the MVR,

when the power supply cable is disconnected) in the following

cases:

• Power indicator is not on when the power supply cable is

connected;

• The device does not switch from the standby to the recording

or control mode;

• The device fails to function properly.

• To restart the MVR, turn the power off, remove the battery

cover (p. 9, c. 7) and carefully remove the battery from the slot

for at least 5 seconds. Then put the battery back, close the

cover and reconnect the power supply cable.

Important information

Warning!

ENG