Chicago Pneumatic CP3119-12ES3 [3/27] Disassembly and reassembly instructions
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Chicago Pneumatic CP3119-12ES3 [3/27] Disassembly and reassembly instructions

Chicago Pneumatic CP3119-12ES3X [3/27] Disassembly and reassembly instructions
10mm
Original instructions.
© COPyRIGHT 2011, CHICAGO
PNEUMATIC
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
INSTRUCTIONS
This product is designed for removing
material using abrasives. No other
use permitted. For professional use
only. Before servicing the power tool,
the supply of compressed air must be
disconnected or shut off.
When disposing of components,
lubricants, etc … ensure that the
relevant safety procedures are carried
out.
For dust extraction, please contact your
local sales.
The tool is designed for a working
pressure of 6.3 bar (90 psig). The
compressed air must be clean. The
installation of a lter is recommended.
For maximum efciency and
performance, comply with the
specication of the air hose (antistatic
hose). (Refer to gure no.1 for
compressed air connection).
A: Ømini = 10mm (3/8")
B: 7 m max.
A
B
To obtain maximum efciency from the
pneumatic tool, preserve its features
and avoid repeated repairs, a routine
inspection and repair programme
are recommended at least every 500
hours, the intervals between the various
inspections depending on the amount of
exertion on the power tool.
Check the free speed of the tool
at regular intervals and after each
operation or maintenance task. Remove
the abrasive to check the speed. The
maximum allowed speed shown on
the tool must not be exceeded and the
vibration level must not be excessive.
This tool is tted with blades which can
operate without lubricated air. However,
a small amount of oil allows the tool to
provide full power and lengthens its life.
The use of dry air with no trace of oil
may reduce the life of blades.
DISASSEMBLy AND REASSEMBLy
INSTRUCTIONS
Disconnect the machine from the
compressed air supply. Remove all
accessories.
Disassembling the turbine
● Remove the turbine from the housing (15).
● Extract the lock ring (27).
● Unscrew the speed governor (16).
Left thread (see gure 2).
● Disassemble the turbine (see gure 3).
● CLAMP THE ROTOR SLIGHTLY IN A VICE
FITTED WITH LEAD JAWS, then unscrew
the coupling fork (29).
Reassembling the turbine
● Proceed in reverse order with respect to
disassembly.
Be careful with the direction for
assembling the blades.
● Apply a small quantity of "Loctite 243" on the
thread of the governor (16) before tightening
it to a torque of 2 Nm.
● Make sure that the turbine is correctly
positioned (see gure 4).
1
3 42
Part n° 6159949820
Issu n° 01
Series C
09/2011
3 / 27

Содержание

Похожие устройства

Скачать