Tp-Link TL-WN310G [9/37] Chapter2 installation guide

TL-WN310G 54M

Wireless

Adapter User Guide

- 3 -

Chapter2 Installation Guide

2.1 Hardware Installation

To install the adapter, follow these steps listed below:

1. Locate an available CardBus slot on your laptop.

2. With the connector pin end facing the CardBus slot and the label facing up, slide the Adapter

into the CardBus slot until it locks in place.

3. The promoted Found New Hardware Wizard screen will pop up when the adapter is

installed correctly.

2.2 Software Installation

2.2.1 Overview

The Adapter’s Setup Wizard will guide you through the Installation procedure for Windows 2000,

XP86,

Vista32, Vista64. The Setup Wizard will install the TP-LINK Wireless Client Utility

(TWCU) and drivers.

When you install the hardware before installing the software, the system will prompt “Found

New Hardware Wizard”, click Cancel, and run the Setup Wizard program on the CD-ROM.

The Setup steps for Windows 2000, XP are very similar. The following setup steps are for

Windows XP.

2.2.2 Software Installation for Windows XP

Insert the Resource CD into your CD-ROM drive, and open the folder named

TL-WN310G. Choose the proper folder according to your operating system and

double-click Setup.exe to load the following screen. And then click Next To continue

the installation.