Beko CE 58100 Инструкция по эксплуатации онлайн [63/72] 38923

Содержание

Oven interior Before switching on again ensure that all controls are in the OFF position Take out all trays and the grill out of the oven Clean out the interior with a piece of moist soapy cloth Then clean it once more with a wet piece of cloth and let it to dry the plastic knobs as damage will occur Do not attempt to remove any of the control knobs from the panel as this may cause damage and is a safety hazard Do not use dry powder agents for cleaning Oven door Special cleaners that are commercially available may be used after carefully reading the warning that are written on the labels Wipe over the door outer panel with a cloth wrung out in hot soapy water then after wiping with a cloth wrung out in clear water Do not use scouring pads or abrasive powder which may scratch the surface Take care during cleaning not to damage Warning Never clean the inside of the oven and trays with hard brushes steel pads or knives Special cleaners that are commercially avaible may be used after carefully reading the warning that are written on the labels or distort the door seal Removing the interior glass of the oven door When you wish to clean the interior glass of the oven door use a screwdriver to remove the top and bottom washers that connect the interior glass to the door take the glass out and clean and rinse it off using a piece of cloth moistened with soapy water After drying position the gasket back into its place and fit the glass onto the door Catalytic enamelled models The oven interior of this model is coated with catalytic enamel since the catalytic enamel cleans itsellf you do not have to perform an extra cleaning after the cooking operation If your oven obtains steel rack To clean the steel rack unscrew the 4 screws After cleaning operation assemble the steel rack to the oven body again Control panel Replating the oven lamp 1 Unplug the power cable 2 Then remove theprotective glass cover of the lamp inside your oven by turning it counterclockwise 3 Then remove the bulb by turning it counterclockwise 4 After installing the correct bulb obtained from an Authorized Service reinstall the protective glass of the lamp Wipe over the control panel with a damp cloth and polish with a dry cloth Do not use oven cleaners or aerosols scouring pads or abrasive powder for cleaning 29