Tp-Link TL-SL1117 [8/12] Mounting the sfp module for tl sl1351 only

2.3 Mounting the SFP Module (for TL-SL1351 Only)

The front panel of the TL-SL1351 consists of a SFP module, which support The

Hot Plug- And- Draw. Should fixed the SFP into SFP pluggable when use the SFP

module. The switch could identify and configure the SFP module automatically.

2.4 Power on

TL-SL1210/TL-SL1117/TL-SL1226/TL-SL1351 Gigabit Switch is powered by AC

power supply. Powering on the Switch, it will automatically initialize and its LED

indicators should respond as follows:

1) All of the LED indicators will flash momentarily for one second, which

represents a resetting of the system.

2) The power LED indicator will remain ON.

Chapter 3 Identifying External Components

This Chapter describes the front panel, rear panel and LED indicators of the

Switch (here takes TL-SL1351 for example).

3.1 Front Panel

The front panel of TL-SL1351 consists of switch LED indicators, 48 10/100Mbps

RJ-45 ports, 2 10/100/1000Mbps RJ-45 ports and 1 SFP module.

Note:

The SFP module is only for TL-SL3151.

Figure 3-1 TL-SL1351 Switch Front Panel sketch

The LED indicators include Power, Link/Act, 1000Mbps and 100Mbps LED

indicators, which are used for monitoring and pre-troubleshooting of the Switch.

The following section explains the status of LED indicators for the Switch along

with an explanation of each indicator.

¾ Power LED: This indicator will light solid red when the Switch powers up. If

the LED is not lit, please check the power supply and connection.