Tp-Link TL-WA801ND [61/76] Diagnostic

TL-WA801ND 300Mbps Wireless N Access Point User Guide

¾ SNMP Agent - Select the radio button before Enable will enable this function if you want to

have remote control through SNMPv1/v2 agent with MIB-II. Select the radio button before

Disable will disable this function. The default setting is Disable.

¾ SysContact - The textual identification of the contact person for this managed node.

¾ SysName - An administratively-assigned name for this managed node.

¾ SysLocation - The physical location of this node.

)

Note:

Specifying one of these values via the Device's Web-Based Utility makes the corresponding object

read-only. If there isn't such a config setting, then the write request will succeed (assuming

suitable access control settings), but the new value would be forgotten the next time the agent was

restarted.

¾ Get Community - Enter the community name that allows Read-Only access to the Device's

SNMP information. The community name can be considered a group password. The default

setting is “public”.

¾ Get Source - Get source defines the IP address or subnet for management systems that can

read information from this 'get' community device.

¾ Set Community - Enter the community name that allows Read/Write access to the Device's

SNMP information. The community name can be considered a group password. The default

setting is “private”.

¾ Set Source - Set source defines the IP address or subnet for management systems that can

control this 'set' community device.

)

Note:

A restricted source can be a specific IP address (e.g. 10.10.10.1), or a subnet - represented as

IP/BITS (e.g. 10.10.10.0/24). If an IP Address of 0.0.0.0 is specified, the agent will accept all

requests under the corresponding community name.

Click the Save button to save your settings.

4.7.2 Diagnostic

Selecting System Tools > Diagnostic allow you to check the connections of your network

components on the screen shown in Figure 4-31.