D-Link DGS-3420-28SC [232/338] Show traffic_segmentation

DGS-3312SR Layer 3 Gigabit Switch

226

Example usage:

To configure ports 1 through 9 to be able to forward frames to port 10 through 12:

DGS-3312SR:4# config traffic_segmentation 1

:1-1:9 forward_list 1:10-1:12

Command: config traffic_segmentation 1

:1-1:9 forward_list 1:10-1:12

Note: If a port in forward_list belongs to a different slave form

source_port, all ports on the slave will be added in forward_list.

Success.

DGS-3312SR:4#

show traffic_segmentation

Purpose Used to display the current traffic segmentation configuration on the

switch.

Syntax

show traffic_segmentation <portlist>

Description

The show traffic_segmentation command is used to display the

current traffic segmentation configuration on the switch.

Parameters

<portlist> − Specifies a range of ports for which the current traffic

segmentation configuration on the switch will be displayed. The port

list is specified by listing the lowest switch number and the

beginning port number on that switch, separated by a colon. Then

the highest switch number, and the highest port number of the range

(also separated by a colon) are specified. The beginning and end of

the port list range are separated by a dash. For example, 1:3

specifies switch number 1, port 3. 2:4 specifies switch number 2,

port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and

switch 2, port 4 − in numerical order.

Restrictions The port lists for segmentation and the forward list must be on the

same switch.

Example usage:

To display the current traffic segmentation configuration on the switch.

DGS-3312SR:4#show traffic_segmentation 1:1-1:12

Command: show traffic_segmentation 1:1-1:12

Traffic Segmentation Table

Port Forward Portlist

---- ----------------------------

1:1 1:1-1:12,2:1-2:12