D-Link DGS-3420-28SC [235/338] Config stacking mode

DGS-3312SR Layer 3 Gigabit Switch

229

config stacking mode

Then the highest switch number, and the highest port

number of the range (also separated by a colon) are

specified. The beginning and end of the port list range are

separated by a dash. For example, 1:3 specifies switch

number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-

2:4 specifies all of the ports between switch 1, port 3 and

switch 2, port 4 − in numerical order.

Restrictions Only administrator-level users can issue this command.

Usage Example

To globally enable stacking:

DGS-3312SR:4#config stacking mode enable

Command: config stacking mode enable

The new stacking mode configuration must be saved and the system

restarted to put the new settings into effect.

If you do not save the changes now,they will be lost.

Do you want to save the new system configuration to NV-RAM and restart

now?(y/n)

It is necessary to save the stacking mode settings and restart the system. If you want to save and restart press Y. It will take a

few minutes for the system to reboot.

It is also possible to use any of the built-in combination ports for stacking. Follow the example below to enable stacking for a

built-in port.

To configure built-n port number 4 to function as a stacking port:

DGS-3312SR:4#config stacking mode enable ports 4

Command: config stacking mode enable ports 4

The new stacking mode configuration must be saved and the system

restarted to put the new settings into effect.

If you do not save the changes now, they will be lost.

Do you want to save the new system configuration to NV-RAM and

restart now?(y/n)

Success.

DGS-3312SR:4#

It is necessary to save the stacking mode settings and restart the system. If you want to save and restart press Y. It will take a

few minutes for the system to reboot.