Hama Color Edge 00136294 Инструкция по эксплуатации онлайн [5/97] 373147

4.2 Replacing the batteries

Note –Replacing the batteries

•Note that the stations have to be resynchronised each time after you change the batteries in the

measuring or base station.

•Todothis, remove the batteries from the other station and then reinsert them, or change them

as required.

Measuring station

•Ifthe symbol is displayed (next to ‘OUTDOOR’), replace the two AA batteries of the measuring

station with two new ones.

•Open the battery compartment (28), remove and properly dispose of the dead batteries and insert

two new AA batteries with the correct polarity.Then close the battery compartment cover.

Base station

•Ifthe symbol is displayed (next to ‘INDOOR’), replace the three AAA batteries in the base device

with new ones.

•Open the battery compartment (24), remove and properly dispose of the dead batteries and insert

three new AAA batteries with the correct polarity.Then close the battery compartment cover (24).

5. Installation

Note –Installation

•Werecommend initially placing the base and measuring stations in the intended locations

without installing them and making all the settings described in 6. Operation –todo.

•Only install the stations once the appropriate settings have been made and astable wireless

connection is established.

Note

•The wireless transmission range between the measuring station and base station is up to 30 m

in open spaces.

•Beforeinstallation, ensurethat wireless transmission will not be disrupted by interference or

obstacles like buildings, trees, vehicles, high-voltage lines, etc.

•Toavoid transmission interference, do not operate adjacent wireless devices on the same

frequency (433 MHz).

•Beforethe nal installation, ensurethat thereissucient reception between the intended

installation locations.

•When installing the measuring station, ensurethat it is protected from direct sunlight and rain.

•The international standardheight for measuring air temperatureis1.25 m(4ft) above ground.

Warning

•Buy special or suitable installation material from aspecialised dealer for wall-mounting.

•Ensurethat no faulty or damaged parts areinstalled.

•Never apply force during installation. This could damage the product.

•Beforeinstallation, ensurethat the chosen wall is suitable for the weight to be mounted, and

make surethat thereare no electrical wires, water,gas or other lines at the installation site

on the wall.

5.1 Base station

•Use the base to position the base station on alevel surface.