D-Link DWL-1000AP [10/24] Installation

Installation

Follow these steps to install the DWL-1000AP:

1. Mount the DWL-1000AP firmly to the wall on the position that is determined

during the site survey. A drill model is supplied as a separate sheet with this

manual.

2. Make sure the antennas are in a vertical position (if not, rotate over 90 degrees).

3. Insert the power connector.

4. Attach the UTP Ethernet cable to the Access Point.

5. Switch on the Access Point.

At the front of the Access Point you will see three LEDs.

If all goes well, the middle LED (power) is green and the leftmost (WLAN) and

rightmost (wired network) LEDs flash whenever there is traffic on the respective

networks which is at least ten times per second for the wireless LAN because of

'beacons'.

The Access Point automatically selects the medium attached. When the cable network is

detected, the network LED will turn yellow.

You can reset the Access Point's settings to factory defaults by pushing a paperclip in the

little hole next to the power switch. The sequence of the ACT is on, and holding until the

LED goes off.

When you push a paperclip in the reset hole while the Access Point is switched on, only

the lock set by APManager(tm) (Par 4.5) is deactivated.

APManager Features

APManager(tm) provides a consistent view of the Wireless network. The systems

administrator can use APManager(tm) to control a large number of DWL-1000AP

Access Points from a single location. The Access Points are remotely updated via the

SNMP (Simple Network Management Protocol).

Features:

• Adding and removing Access Points