D-Link DWL-1000AP Инструкция по эксплуатации онлайн [17/24] 41452

If you do not have a DHCP server, it is possible to manually set the IP address of your

Access Points from APManager(tm).

1. Physically connect the Access Points and the computer on which you run

APManager(tm) to the same Ethernet segment.

2. Make sure there is no DHCP or BOOTP server running.

3. Switch the Access Points on. The network LED should light up in red.

4. Configure the Access Points to be part of the desired network. See the Network

Settings Dialog for details.

5. Enter the hardware addresses of the Access Points by hand using the Edit/Insert

Access Point menu command or clicking the appropriate toolbar button.

6. For each Access Point select Edit/Set IP Address menu command and enter the

required IP address manually. As soon as you press apply, the Access Point

should acquire the designated IP address. Within a few seconds the network LED

on the Access Point should light up green.

You may or may not be able to communicate with the Access Point, depending on the

validity of the IP address in the current Ethernet segment.