D-Link DP-311P — настройка веб-конфигурации для беспроводного принт-сервера [7/68]

Превью страниц Страница 7 / 68

Using the Web Configuration

On the following pages you will find a description of each of the screens that are available to

you for the web configuration of the DP-311P.

Re-power the DP-311P by pulling the power adapter plug out and re-inserting it.

After you have finished configuring the DP-311P, in order for the changes to

take effect, you must toggle the mode switch on the rear panel of the print

server back to “Normal” mode.

Set the switch to Config mode on the rear panel of the DP-311P.

Change your wireless adapter setting to Ad-Hoc or Peer-to-Peer mode. (Open

the Configuration utility for your network adapter and make sure that your

network adapter is set to Ad-Hoc mode in your configuration settings.)

(For D-Link network adapters, you can open the web-based configuration utility

and go to the Site Survey function and select the SSID named WLAN-PS. The

Channel is 1 and WEP is set to Disable. The network adapter will now be in Ad-

Hoc mode.)

Change the wireless adapter IP Address so that it is in the same IP Address range

as the DP-311P (192.168.0.x). For instructions on changing the IP Address,

please refer to the Networking Basics section in this manual. The subnet mask is

255.255.255.0.

Restart the computer.

Open your web browser and input the IP Address of your wireless print server.

The default IP Address is 192.168.0.10.

you begin configuring the DP-311P:

Before

you have completed the configuration:

After