Tp-Link TX-6610 V4 — установка и настройка GPON терминала: пошаговое руководство [1/2]

Содержание

• Tx 6610 p.1
• Register the terminal p.1
• Quick installation guide p.1
• Port gigabit gpon terminal p.1
• Internet p.1
• If the gpon led is solid on please skip to connect to the internet p.1
• Connect to the internet p.1
• Connect the hardware p.1
• A with the terminal powered on press and hold the reset button on the rear panel of the terminal until all leds turn back on momentarily then release the button p.2
• Reset button press and hold for 5 seconds p.2
• A to change the computer s network settings follow the steps below p.2
• Q4 how do i restore my terminal to its factory default settings p.2
• A device is connected to the lan port p.2
• Q3 what can i do if i cannot access the internet p.2
• Q2 what can i do if i cannot access the web management page p.2
• 2015 tp link p.2
• Q1 how do i change my computer s setting to obtain an ip address automatically p.2
• Power is on p.2
• Power is of p.2
• Pon certification page a3 unplug and reconnect the fiber cable to the terminal wait for 2 minutes and try again a4 make sure that you follow your isp s specific instructions to connect to the internet a5 make sure that the computer connected to the terminal is set to obtain an ip address automatically refer to q1 for instructions a6 contact your isp if the problem still exists p.2
• No optical signal is received or the received signal is too weak p.2
• No device is connected to the lan port p.2
• The terminal is unable to transmit optical signal p.2
• Led status indication p.2
• The terminal is trying to register with the isp p.2
• Led indicators p.2
• The terminal is registered with the isp p.2
• For advanced configuration refer to the user guide which can be downloaded at http www tp link com en download center html p.2
• Flashing p.2
• The terminal is receiving optical signal properly p.2
• Faq frequently asked questions p.2
• The terminal is not yet registered with the isp p.2
• A1 make sure that the computer is properly connected to the terminal via the ethernet cable a2 make sure that the computer connected to the terminal is set to obtain an ip address automatically refer to q1 for instructions a3 make sure that http 192 68 is correctly entered or use another web browser and try again a4 disable then enable the network adapter being used a5 restore the terminal to its factory default settings and reconfigure your terminal by following the instructions in this quick installation guide p.2
• The lan port is transmitting or receiving data p.2