Rigol DL3031A [122/163] Select the power on value

RIGOL Chapter 2 Front Panel Operations

2-92 DL3000 User’s Guide

System

Press Utility to enter the system utility function interface. By default, the system

setting tab is selected. As shown in Figure 2-52, if the scrollbar is shown at the right

side of the interface, it indicates that not all system settings are displayed in the

current interface. At this time, press the Up/Down arrow key to go to the next page.

Select the System Language

The interface display, help information, and prompt messages are displayed in both

Simplified Chinese and English. The setting is stored in the non-volatile memory,

which will not be affected even if you restore the load to its factory defaults.

In the system setting tab, press the Up/Down arrow key to switch the parameter

focus to "Language", and then press the Left/Right arrow key or use the knob to

select the desired language: Chinese or English.

Select the Power-on Value

Select "Default" or "Last" as the power-on system state.

 Default: restores factory defaults when the instrument is powered on, refer to

Table 2-3.

 Last: restores its last state when the instrument is powered on.

In the system setting tab, press the Up/Down arrow key to switch the parameter

focus to "Power-on", and then press the Left/Right arrow key or use the knob to

select the desired power-on state: Default or Last. The setting is saved to the internal

non-volatile memory.

Turn On/Off the Beeper

When the beeper is turned on, the icon is displayed in the status bar. The beeper

sounds when you perform the following operations.

 When you press the keys on the front panel;

 When you rotate the knob;

 When a prompt message or an alarm is displayed;

 When the test is passed or failed.

In the system setting tab, press the Up/Down arrow key to switch the parameter

focus to "Beeper", and then press the Left/Right arrow key or use the knob to turn on

or off the beeper.