Rigol DL3031A [127/163] View usb id

Chapter 2 Front Panel Operations RIGOL

DL3000 User’s Guide 2-97

View USB ID

Use the USB cable to connect the load to the PC via the USB DEVICE interface. Then,

the load can be controlled remotely.

Press Interface to enter the communication interface tab, and then press the USB

key to select the "USB" tab, as shown in Figure 2-54.

Figure 2-54 "USB" Tab Interface

In the "USB" interface, the contents of USB ID is read-only. You can only view the ID

of the USB, but you are not allowed to edit it.

Set the parameters for the RS232 interface

Use the 9-pin RS232 cable (female-to-female, cross-over) to connect the RS232

interface to the PC, and set the interface parameters (such as baud rate, parity, etc.)

that match the PC. Then, you can remotely control the instrument. The RS232

interface is shown in the following figure. For the descriptions of the pins, refer to

Table 2-2.

Figure 2-55 RS232 Interface

Table 2-2 Descriptions of RS232 Interface Pins

Name

Description

Not connected

TXD (Transmit Data)

Transmit data

RXD (Receive Data)

Receives data.