Vitek VT-5009 SR [11/48] English

PROGRAM Function:

PROGRAM position is selected on screen, press the [V+] or [V] button to set up or down the program channel and select

your desired program from 0 to 99.

STEREO Function:

STEREO position is selected on screen, press [V+] or [V] button to set stereo ON or OFF mode. Normally the stereo function

is set to "ON" state.

(2) SYSEM of FM Radio Mode Operation:

Refer to section (4) TV SYSTEM operation and detail about SWAP and COPY function. C. SYS., S. SYS., WEAK SIGNAL func

• When you want to watch other source device with AVIN and connect the source signal to the unit and yellow colour jack

connect to video signal, Red colour jack connect to Audio Right channel, White colour jack connect to audio left channel.

• Press the [TV/AV/FM] button to select AV channel on screen. Then you can watch the video picture

NOTE: In AV mode. The PRESERT, S. SYS., SWAP, COPY, WEAK SIGNAL setting menu will disappear on the screen.

(F) Remote Control

• In the remote handset, press the MUTE button to temporary silences audio output, and press button again back to normal

state.

• Press the button to alternate between previous and current program.

• Press the / button to set direct key digit number 1, 2 or 3.

• Press the digit button 0  9 it will tune your desired program directly.

on.

• If used the battery power set the battery mode switch at "Power" position and release the plug of AC/DC adaptor or Car

power.

Warning: Do not use NONRECHARGEABLE Batteries to charge. The batteries will explode and damage the unit.

Caution: DO NOT charge continuously for over 24 hours, as it will deteriorate the performance of the rechargeable

batteries.

NOTE: If rechargeable batteries are being charged for the first time, it will take approximately 15 hours to be full charged.

If the operating time is reduced drastically even when the rechargeable batteries are properly recharged replace a

new set of rechargeable batteries.

ENGLISH