Wolf-garten SDL 2500 [11/106] J the toggle switch enables freeing trapped material

Wolf-garten SDL 2500 [11/106] J the toggle switch enables freeing trapped material
11
G
Switching on / off
z Press the green button to switch on .
z Press the red button to switch off .
3 The machine has a circuit breaker to prevent switching
back on unintentionally after a power cut.
Overload protection
3 An overloading of the appliance (e.g. culminating in the
blocking of the cutting roller) can lead to the standstill
of the appliance after a few seconds. To protect the
motor from damage the appliance is automatically
disconnected from the mains by the overload
protection.
z Before putting into operation again wait for at least one
minute before immediately pressing the reset button
and then ON/OFF switch.
Toggle switch
3 The toggle switch enables freeing trapped material.
Position
The blade pulls in the crushed material.
Position
The blade rotates backwards and frees any trapped material.
1. Toggle switch to position .
2. Press green button
and do not release.
3 The toggle switch can only be used when the appliance
is switched off.
Special instructions for chopping
z Chop branches, twigs and wood shortly after cutting (this
chopped material will become very hard once it has dried out,
therefore the maximum diameter which can be processed is
less).
z Remove the side shoots on severely ramified branches.
z When processing garden or kitchen waste with a high water
content with a tendency to stick, crush alternately with wooden
chopping material to avoid blocking the appliance).
z Do not allow the chopping material in the area of the discharge
opening to accumulate too high. This can lead to material
which is already chopped blocking the discharge channel.
This can cause a kickback of the material through the filling
opening.
z Ensure that the maximum branch diameter for processing
permitted for your appliance is observed.
z The blade unit pulls in the chopping material largely by itself.
z Do not overload or block the motor in the case of tough
branches by frequently pulling back the branch.
B
C
A
E
D
D
B

Содержание

Switching on off Toggle switch j The toggle switch enables freeing trapped material Position E The blade pulls in the crushed material Position D The blade rotates backwards and frees any trapped material 1 Toggle switch to position D 2 Press green button B and do not release Press the green button to switch on B Press the red button to switch off C j The machine has a circuit breaker to prevent switching back on unintentionally after a power cut Overload protection i An overloading of the appliance e g culminating in the blocking of the cutting roller can lead to the standstill of the appliance after a few seconds To protect the motor from damage the appliance is automatically disconnected from the mains by the overload protection Before putting into operation again wait for at least one minute before immediately pressing the reset button A and then ON OFF switch GB j The toggle switch can only be used when the appliance is switched off Special instructions for chopping Chop branches twigs and wood shortly after cutting this chopped material will become very hard once it has dried out therefore the maximum diameter which can be processed is less Remove the side shoots on severely ramified branches When processing garden or kitchen waste with a high water content with a tendency to stick crush alternately with wooden chopping material to avoid blocking the appliance Do not allow the chopping material in the area of the discharge opening to accumulate too high This can lead to material which is already chopped blocking the discharge channel This can cause a kickback of the material through the filling opening Ensure that the maximum branch diameter for processing permitted for your appliance is observed The blade unit pulls in the chopping material largely by itself Do not overload or block the motor in the case of tough branches by frequently pulling back the branch 11

Скачать