Homa H832 - 45/1,1D [10/12] Months of warranty
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Homa H832 - 45/1,1D [10/12] Months of warranty

Homa H832 - 45/1,1D [10/12] Months of warranty
10
- Ball bearings: Check the shaft for noisy or heavy opera-
tion (turn the shaft by hand). Replace defective ball bear-
ings. A general overhaul of the pump is usally required in
case of defective ball bearings or poor motor function.
This work must be carried out by an authorized
service workshop.
- Cable entry
: Make sure that the cable entry is watertight
and that the cables are not bent sharply and/or pinched.
Additionally at pump types with oil chamber:
- Oil level and oil condition in oil chamber:
Put the pump in horizontal position, so that the screw of
the oil chamber is above (at larger pumps: one of both
screws). Remove the screw and infer a small quantity of
oil. The oil becomes greyish white like milk if it contains
water. This may be the result of defective shaft seal.
In this case leave the condition of the shaft seals by a
HOMA Service to examine.
The oil should be replaced after 3000 operating hours.
Oil type: Shell Tellus C22, degradable HOMA-Atox (avail-
able on request). Used oil is to be disposed accordingly.
Servicing Contract
For a regular expert execution of all necessary mainte-
nance and inspection we recommend the conclusion of a
servicing contract by our HOMA Service. Please contact
our HOMA customer service.
10. Fault Finding Chart
Before maintenance or repair disconnect the pump
from the power supply to avoid accidental starting of the
pump!
Fault Cause Remedy
Motor does not start.
Fuses blow or motor
starter trips out immedi-
ately. Caution: Do not
start again!
• Supply failure; short-
circuit; earth-leakage;
fault in cable or motor
winding
• Have the cable and
motor checked and
repaired by a quali-
fied electrician
• Fuses blow due to use
of wrong type of fuse
• Install fuses of the
correct type
• Impeller blocked by
impurities
• Clean the impeller
• capacitor defective • Check the capacitor
Pump operates, but
motor starter trips out
after a short while
• Low setting of thermal
relay in motor starter
• Set the relay in
accordance with the
specifications on the
pump label
• Increased current
consumption due to
large voltage drop
• Measure the voltage
between two motor
phases. Tolerance:
± 10%
• Impeller blocked by
impurities. Increased
current consumption in
all three phases
• Clean the impeller
Pump operates at
below-standard
• Impeller blocked by
impurities
• Clean the impeller
performance and power
consumption
• •
Oil in the medium
• Wear-out of the radial
shaft ring
• Replace the radial
shaft ring, change
the oil
Pump operates, but
gives no liquid
• Discharge valve
closed or blocked
• Check the discharge
valve and possibly
open and/or clean
• Non-return valve
blocked
• Clean non-return
valve
• •
We grant for the described product in the warranty receipt a
warranty of declared duration in the warranty receipt. The war-
ranty starts with the first start up, latest with the day of sale. A
warranty claim can be raised only by presentation of the fill in
warranty receipt together with the purchase receipt.
Our warranty extends only the removal of material defects or
production defects. Costs for removal and installation of the
complained product at the installation place, costs for the ride of
the mechanicians to the location and from the installation place
as well as costs for transport are not components of our war-
ranty. Complains caused by installation faults or operating faults,
unsuitable operation conditions, deficient care or improper efforts
of repair are out of the question of warranty as well as normal
wear. Hereby arised costs, especially costs for checking and
transport are bearing by the sender or operator of the pump. This
is also valid for an asserted warranty claim if a check results that
the unit works faultless and is free of defects. All products have a
high quality standard. Each product is defeated by a streng
technical end control before delivery. If the unit still gives an
occasion for a legitimated complain, you have the claim of an
appropriated correction free of charge. Warranty repairs only
must lead from the manufacturer or an authorized agency. Trials
of repair by the customer or non-authorized persons during the
warranty, causes an extinguishing of the warranty. A warranty
repair achieved by us does not extend the warranty period. Re-
placed spare parts give no reasons for a new warranty period.
Extensive claims are excluderd, especially such as diminution,
change or compensation also for any kind of follow up damages.
To guarantee a quick transaction of a warranty claim, please
return the product together with the warranty receipt, purchase
receipt and declaration of defect carriage paid to the manufac-
turer (for the adress see warranty receipt).
Claims caused by damages of transport could be only accepted,
if the damage is established or confirmed by delivery in the
presence of the forwarder, parcel service, train or post.
Pump type
No.
Correspond to our warranty conditions
we achieve
12 months of warranty
Warranty Conditions
✂
HOMA Pumpenfabrik GmbH
Industriestraße 1
D-53819 Nk.-Seelscheid
Telefon: + 49 (0) - 22 47 - 70 20
Telefax: + 49 (0) - 22 47 - 7 02 44
Train station: D-53819 Nk.-Seelscheid
Warranty receipt

Содержание

Похожие устройства

Скачать