Elenberg DW-9205 [36/40] Cold water connection

Electrical connection

After making sure that the voltage and the frequency values for the

current in the home correspond to those on the rating plate and that

the electrical system is sized for the maximum voltage on the rat-

ing plate, insert the plug into an electrical socket which is earthed

properly. If the electrical socket to which the appliance must be

connected is not appropriate for the plug, replace the socket, rather

than using an adaptors or the like as they could cause overheating

and burns.

Cold Water Connection

Connect the cold water supply hose to a

threaded 3/4 (inch) connector and make sure

that it is fastened tightly in place.

If the water pipes are new or have not been

used for an extended period of time, let the

water run to make sure that the water is clear

and free of impurities. If this precaution is not taken, there is a risk

that the water inlet can get blocked and damage the appliance.

Hot Water Connection

The water supply to the appliance can also be connected to the

house hot water line (centralized system, heating system),as long

as it does not exceed a temperature of 60°C. In this case, the wash

cycle time will be shortened by about 15 minutes and the wash ef-

ﬁciency slightly reduced.

The connection must be made to the hot water line following the

same procedures as those for the connection to the cold waterline.

Positioning the Appliance

Position the appliance in the desired location. The back should rest

against the wall behind it, and the sides, along the adjacent cabi-

nets or wall. The dishwasher is equipped with water sup ply and

drain hoses that can be positioned to the right or the left to facili-

tate proper installation.

Leveling the Appliance

Once the appliance is positioned, adjust

the feet (screwing them in or out) to ad-

just the height of the dishwasher, making

it level. In any case, the appliance should

not be inclined more than 2°.

WATER CONNECTION