Fluke 77 IV [4/18] Battery low battery when shown on display

Warning. Read before using the Meter

To avoid possible electrical shock or personal injury, follow these guidelines:

⇒ Use the Meter only as specified in this manual or the protection provided by the Meter might be impaired.

⇒ Do not use the Meter or test leads if they appear damaged, or if the Meter is not operating properly. If in doubt, have the

Meter serviced.

⇒ Always use the proper terminals, switch position, and range for measurements.

⇒ Verify the Meter's operation by measuring a known voltage.

⇒ Do not apply more than the rated voltage, as marked on the Meter, between the terminals or between any terminal and earth

ground.

⇒ Use caution with voltages above 30 V ac rms, 42 V ac peak, or 60 V dc. These voltages pose a shock hazard.

⇒ Disconnect circuit power and discharge all high-voltage capacitors before testing resistance, continuity, diodes, or

capacitance.

⇒ Do not use the Meter around explosive gas or vapor.

⇒ When using the test leads, keep your fingers behind the finger guards.

⇒ Remove test leads from the Meter before opening the Meter case or battery door.

Symbols

AC (Alternating Current)

Fuse

DC (Direct Current)

Conforms to European Union directives

DC/AC

Canadian Standards Association

Earth ground

Double insulated

Important Information; see manual

Hazardous Voltage

Battery (Low battery when shown on

display)

Underwriters Laboratories, Inc.

Meter in accordance with IEC 61010-1. 54CJ

Inspected and licensed by TÜV

(Technischer Überwachungs Verein)

Product Services

;

N10140

Conforms to relevant Australian standards

VDE (Verband Deutscher Electroniker)