Qtech QSW-2910-28T-AC [135/212] Sntp client multicast ttl configuration

+7(495) 797-3311 www.qtech.ru

Москва, Новозаводская ул., 18, стр. 1

135

For example:

!Configure broadcastdelay to be 1 second

QTECH(config)#sntp client broadcastdelay 1000

10.2.5 SNTP client multicast TTL configuration

Use following command to configure ttl-value of multicast packet:

sntp client multicast ttl ttl-value

no sntp client multicast ttl

This command should be effective by sending packet through multicast address in anycast

operation mode. In order to restrict the range of sending multicast packet, TTL-value setting is

suggested. The default ttl-value is 255.

For example:

!Configure TTTL-value of sending multicast packet to be 5

QTECH(config)#sntp client multicast ttl 5

10.2.6 SNTP client poll interval configuration

Use following command to configure poll-interval of SNTP client in unicast or anycas.:

sntp client poll-interval seconds

no sntp client poll-interval

Only in unicast and anycast mode, configured poll interval can be effective. SNTP client sends

requirement in a poll interval to the server to adjust current time.

For example:

!Configure poll-interval to be 100 seconds

QTECH(config)#sntp client poll-interval 100

10.2.7 SNTP client retransmit configuration

Uses following command to configure retransmit times inunicast and anycast operation mode.:

sntp client retransmit times

no sntp client retransmit

sntp client retransmit-interval seconds

no sntp client retransmit-interval

This command is effective in unicast and anycast operation mode. SNTP requirement packet

is UDP packet, overtime retransmission system is adopted because the requirement packet

cannot be guaranteed to send to the destination. Use above commands to configure retransmit