Qtech QSW-3200-28FC [20/136] Manage switch by hyper terminal
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Qtech QSW-3200-28FC [20/136] Manage switch by hyper terminal

Qtech QSW-3200-24T [20/136] Manage switch by hyper terminal
+7(495) 797-3311www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
9
By Web browser,such as Internet Explorer managing system
1.4.1. Manage switch by hyper terminal
Use hyper terminal (or simulation terminal software) connect to Console to access system
command line interface (CLI) by hyper terminal.
Configuration: Open «file» -> «attribute» menu, popping up a window. Enter configuration to
restore it to default value, and click «setting» and then choose «auto-detect» in the pulldown
list of «terminal simulation» and click [ok]. After the successful connection and seeing logging
in interface of operation system in terminal, configure switch by command line interface. The
steps are as following:
Step 1: Connect switch Console with computer serial port;
Step 2: After the switch power on and system successful booting, logging in prompt can be
seen:
Username(1-32 chars):
Step 3: Input correct user name, press enter button, then input corresponding password. If it is
the first time to logging in switch, use default user name admin and its password 123456 to log
in and operate as system administrator. If your own user name and password exist, log in with
your own user name and password;
Step 4: After successfully logging in, following information is displayed:
QTECH>
Step 5: As administrator, after entering privileged mode, use copy running-config startup-
config command to save configuration.
QTECH#copy running-config startup-config
When following information is displayed:
Startup config in flash will be updated, are you sure(y/n)? [n]y
Building, please wait...
It means system is saving configuration. Please wait, then the prompt is:
Build successfully.
It means current configuration is saved successfully.
Following information is displayed when system booting:
Ready to load startup-config, press ENTER to run or CTRL+C to cancel:
Press enter button to make saved configuration be effective, and press CTRL+C to restore
system default configuration.
Step 6: Administrator can use stop connection when overtime, while normal user can use this
function in user mode. Input timeout command to configure the overtime of user’s logging in to
be 20 minutes. And use no timeout command to configure overtime to be non-over timing.
Step 7: Input following command after finishing operation to switch:
QTECH#quit
It is used to exit user interface.
1.4.2. Manage switch by telnet
Step 1: Establish configuration environment by connecting computer by network to switch
interface;
Step 2: Run Telnet program in computer;
Step 3: After switch is power on, input switch IP address to connect to switch, and input
configured logging in password according to the prompt, then the command line prompt is
displayed (such as QTECH>) . It will be disconnected after 1 minute when there is not any
input before successfully logging in or wrong inputting of user name and password for 5 times.

Содержание

Похожие устройства

Скачать