Qtech QSW-8200-28T-POEAC- DC Команды для базовой конфигурации онлайн [17/77] 481628

User Manual

Chapter 1. Commands for Basic Switch Configuration 17

www.qtech.ru

 Parameters: New password is the password configured by user; Confirm password is

the password confirmed by user.

 Default: None.

 Command mode: Global Mode.

 Usage Guide: Under the img mode, configure the password of entering the bootrom

mode next time; under the global mode, input this command and the password

according to the prompt and confirm it, then successfully to configure. Notice: the

characters length of the password is from 3 to 32.

 Example:

 switch(config)#set boot password

 New password :*****

 Confirm password :*****

 Set password success!

1.1.28 set default

 Command: set default

 Function: Reset the switch to factory settings.

 Command mode: Admin Mode.

 Usage Guide: Reset the switch to factory settings. That is to say, all configurations

made by the user to the switch will disappear. When the switch is restarted, the

prompt will be the same as when the switch was powered on for the first time.

 Note: After the command, “write” command must be executed to save the operation.

The switch will reset to factory settings after restart.

 Example:

 Switch#set default

 Are you sure? [Y/N] = y

 Switch#write

 Switch#reload

1.1.29 setup

 Command: setup

 Function: Enter the Setup Mode of the switch.

 Command mode: Admin Mode.

 Usage Guide: Switch provides a Setup Mode, in which the user can configure IP

addresses, etc.

1.1.30 show clock

 Command: show clock

 Function: Display the current system clock.

 Command mode: Admin and Configuration Mode.