Qtech QSW-8200-28T-POEAC- DC [70/77] Cluster run

User Manual

Chapter 3. Commands for Cluster 70

www.qtech.ru

 Usage Guide: Execute this command on a switch to change automatically added

members to manually added ones.

 Example: change automatically added members to manually added ones.

 Switch(config)#cluster member auto-to-user

3.9 cluster reset member

 Command: cluster reset member [id <member-id> | mac-address <mac-addr>]

 Function: In the commander switch, this command can be used to reset the member

switch.

 Parameter: member-id: ranging from 1 to 128. Use hyphen “-” or semicolon “;” to

specify more than one member; if no value is provided, it means to reboot all member

switches.

 Default: Boot all member switches.

 Command mode: Admin Mode.

 Instructions: In the commander switch, users can use this command to reset a member

switch. If this command is executed in a non-commander switch, an error will be

displayed.

 Example: In the commander switch, reset the member switch 1.

 Switch#cluster reset member 1

3.10 cluster run

 Command: cluster run [key <WORD>] [vid <VID>]

 no cluster run

 Function: Enable cluster function; the “no cluster run” command disables cluster

function.

 Parameter: key：all keys in one cluster should be the same, no longer than 16

characters.

 vid：vlan id of the cluster, whose range is 1-4094.

 Command mode: Global Mode

 Default: Cluster function is disabled by default, key: NULL(\0) vid：1.

 Instructions: This command enables cluster function. Cluster function has to be

enabled before implementing any other cluster commands. The “no cluster run”

disables cluster function. It is recommended that users allocate an exclusive vlan for

cluster（such as vlan100）

 Note：Routing protocols should be disabled on the layer-3 interface where cluster vlan

locates to avoid broadcasting private route of the cluster.

 Example: Disable cluster function in the local switch.

 Switch (config)#no cluster run