Qtech QSW-8200-28T-POEAC- DC Команды для базовой конфигурации онлайн [19/77] 481628

User Manual

Chapter 1. Commands for Basic Switch Configuration 19

www.qtech.ru

 Command mode: Admin and configuration mode.

 Usage Guide: Check the current usage of memory resource by show memory usage

command. Only the chassis switch uses slotno parameter which is used to show the

memory usage rate of card on the specified slot, if there is no parameter, the default is

current card.

 Example: Show the current usage rate of the memory.

 Switch#show memory usage

 The memory total 128 MB, free 58914872 bytes, usage is 56.10%

1.1.34 show privilege

 Command: show privilege

 Function: Show privilege of the current users.

 Parameter: None.

 Command Mode: All configuration modes

 Example: Show privilege of the current user.

 Switch(Config)#show privilege

 Current privilege level is 15

1.1.35 show privilege mode LINE

 Command: show privilege mode LINE

 Function: Show the level of the specified command.

 Parameters: mode: register mode of the command, ‘Tab’ or ‘?’ is able to show all

 LINE: the command needs to be configured, it supports the command

abbreviation

 Command Mode: Admin and configuration mode

 Usage Guide: LINE must be the whole command format, the abbreviation format is

used to the command which can be analyzed successfully. For half-baked command,

false command about writing and command that abbreviation cannot be analyzed

successfully, the level of them cannot be shown.

 Example: Show the level of privilege command.

 Switch(config)#show privilege exec show ip route

 The command : show ip route

 Privilege is : 15

1.1.36 show tcam usage

 This command is not supported by the switch.

1.1.37 show temperature

 Command: show temperature

 Function: Display the current temputerature of the switch CPU.