Qtech QSW-8200-28T-POEAC- DC Команды для базовой конфигурации онлайн [34/77] 481628

User Manual

Chapter 1. Commands for Basic Switch Configuration 34

www.qtech.ru

 Switch(Config-if-Vlan1)#

1.3.2 interface ethernet 0

 This command is not supported by the switch.

1.3.3 ip address

 Command: ip address <ip-address> <mask> [secondary]

 no ip address [<ip-address> <mask>] [secondary]

 Function: Set the IP address and mask for the specified VLAN interface; the “no ip

address <ip address> <mask> [secondary]” command deletes the specified IP address

setting.

 Parameter: <ip-address> is the IP address in dot decimal format; <mask> is the subnet

mask in dot decimal format; [secondary] indicates the IP configured is a secondary IP

address.

 Default: No IP address is configured upon switch shipment.

 Command mode: VLAN Interface Mode

 Usage Guide: A VLAN interface must be created first before the user can assign an IP

address to the switch.

 Example: Set 10.1.128.1/24 as the IP address of VLAN1 interface.

 Switch(config)#interface vlan 1

 Switch(Config-if-Vlan1)#ip address 10.1.128.1 255.255.255.0

 Switch(Config-if-Vlan1)#exit

 Switch(config)#

 Relative Command: ip bootp-client enable, ip dhcp-client enable

1.3.4 ipv6 address

 Command: ipv6 address <ipv6address | prefix-length> [eui-64]

 no ipv6 address <ipv6address | prefix-length> [eui-64]

 Function: Configure aggregatable global unicast address, site-local address and link-

local address for the interface.

 Parameters: <ipv6address> is the prefix of an IPV6 address; <prefix-length>is the

length of the prefix of an IPV6 address, ranging from 3 to 128; eui-64 means that the

eui64 interface id of the interface will automatically create an IPV6 address.

 Command Mode: Interface Configuration Mode.

 Default: None.

 Usage Guide: The prefix of an IPV6 address should not be a multicast address, or other

kinds of IPV6 addresses with specific usage. Different layer-three VLAN interfaces are

forbidden to share a same address prefix. As for any global unicast address, the prefix

should be limited in the range from 2001:: to 3fff ::, with a length no shorter than 3.

And the prefix length of a site-local address or a link-local address should not be shorter

than 10.