Qtech QSW-8200-28T-POEAC- DC Команды для протокола многоадресной рассылки онлайн [25/39] 481628

User Manual

Chapter 2. IPv6 Multicast Protocol 25

www.qtech.ru

 no ipv6 multicast destination-control <IPADDRESS/M> access-group

<9000-10999>

 Function: Configure multicast destination-control access-list used on specified net

segment, the “no ipv6 multicast destination-control <IPADDRESS/M> access-group

<9000-10999>“command deletes this configuration.

 Parameter: <IPADDRESS/M>: IP address and mask length;

 <9000-10999>: Destination control access-list number.

 Default: None.

 Command Mode: Global Mode.

 Usage Guide: The command is only working under global IPv6 multicast destination-

control enabled, after configuring the command, if MLD-SPOOPING or MLD is enabled,

for adding the members to multicast group. If configuring multicast destination-control

on specified net segment of transmitted MLD-REPORT, and match configured access-

list, such as matching permit, the interface can be added, otherwise do not be added. If

relevant group or source in show ipv6 mld groups detail has been established before

executing the command, it needs to execute clear ipv6 mld group command to clear

relevant groups in admin mode.

 Example:

 Switch(config)#ipv6 multicast destination-control 2008::8/64 access-group 9000

2.1.5 ipv6 multicast destination-control access-group (vmac)

 Command: ipv6 multicast destination-control <1-4094> <macaddr> access-group

<9000-10999>

 no ipv6 multicast destination-control <1-4094> <macaddr> access-

group <9000-10999>

 Function: Configure the IPv6 multicast destination access list used by the specified vlan-

mac, the no operation of this command will delete this configuration.

 Parameters: <1-4094>: VLAN-ID;

 <macaddr>: The source MAC address sending of the MLD-REPORT, the

format of which is“xx-xx-xx-xx-xx-xx”.

 <9000-10999>: Destination access list number.

 Default: Not configured.

 Command Mode: Global Configuration Mode.

 Usage Guide: This command can only take effect when the IPv6 multicast destination

control is globally enabled, after configuring this command, if the MLD-SNOOPING is

enabled, when adding the port to the multicast group, it will be matched according to

the configured access list. Only when the port is matched as permit, will it be added, or

it can not be added.

 Example:

 switch(config)#ipv6 multicast destination-control 1 00-01-03-05-07-09 access-group

9000