Qtech QSW-8200-28T-POEAC- DC Команды для протокола многоадресной рассылки онлайн [26/39] 481628

User Manual

Chapter 2. IPv6 Multicast Protocol 26

www.qtech.ru

2.1.6 ipv6 multicast policy

 Command: ipv6 multicast policy <IPADDRSRC/M> <IPADDRGRP/M> cos <priority>

 no ipv6 multicast policy <IPADDRSRC/M> <IPADDRGRP/M> cos

 Function: Configure IPv6 policy multicast, the no operation of this command is to

cancel the policy multicast of IPv6.

 Parameters: <IPADDRSRC/M>: The source address and the length of the mask of IPv6

multicast.

o <IPADDRGRP/M>: The multicast address of IPv6 and the length of mask of

multicast address

 <priority>: The specified priority, the range of which is <0-7>.

 Default: Not configured.

 Command Mode: Global Configuration Mode.

 Usage Guide: Using this command to configure can change the priority of the multicast

data which is confined by the act of matching of this switch to a specified value, and set

the TOS to the same value simultaneously. Please pay attention to that, for the

messages sent in UNTAG mode, their priority will not be changed.

 Example:

 Switch(config)#ipv6 multicast policy 2008::1/64 ff1e::3/64 cos 4

2.1.7 ipv6 multicast source-control

 Command: ipv6 multicast source-control

 no ipv6 multicast source-control

 Function: Configure to globally enable IPv6 multicast source control, the no operation

of this command is to recover and globally disable the IPv6 multicast source control.

 Parameters: None.

 Default: Disabled.

 Command Mode: Global Configuration Mode.

 Usage Guide: Only when the IPv6 multicast source control is enabled globally, the

source control access list can be applied to ports. After configuring this command, the

IPv6 multicast data received by all the ports will be dropped by the switch if there is no

matched multicast source control entry, that it only the multicast data matched as

PERMIT can be received and forwarded.

 Example:

 Switch(config)#ipv6 multicast source-control

2.1.8 ipv6 multicast source-control access-group

 Command: ipv6 multicast source-control access-group <8000-8099>

 no ipv6 multicast source-control access-group <8000-8099>

 Function: Configure the multicast source control access list used by the port, the no

operation of this command is used to delete the configuration.

 Parameters: <8000-8099>: Source control access list number.