Qtech QSW-8200-28T-POEAC- DC Команды для протокола многоадресной рассылки онлайн [27/39] 481628

User Manual

Chapter 2. IPv6 Multicast Protocol 27

www.qtech.ru

 Default: Not configured.

 Command Mode: Port Configuration Mode.

 Usage Guide: This command can only be successfully configured when the IPv6

multicast source control is globally enabled, after configuring this command, all the

IPv6 multicast messages entering from the port will be matched according to the

configured access list, only when the message is matched as permit, can it be received

and forwarded, or it will be dropped.

 Example:

 switch(config)#inter ethernet 1/0/4

 switch(Config-If-Ethernet1/0/4)#ipv6 multicast source-control access-group 8000

2.1.9 multicast destination-control

 Command: multicast destination-control

 no multicast destination-control

 Function: Configure to globally enable IPv4 and IPv6 multicast destination control, after

configuring this command, IPv4 and IPv6 multicast destination control will take effect at

the same time. The no operation of this command is to recover and disable the IPv4

and IPv6 multicast destination control globally.

 Parameters: None.

 Default: Disabled.

 Command Mode: Global Configuration Mode.

 Usage Guide: Only after globally enabling the multicast destination control, the other

destination control configuration can take effect, the destination access list can be

applied to ports, VLAN-MAC and SIP. After configuring this command, IGMP-

SNOOPING, MLD-SNOOPING and IGMP, MLD will match according to the rules

mentioned above when they try to add ports after receiving IGMP-REPORT and MLD-

REPORT.

 Example:

 switch(config)# multicast destination-control

2.1.10 show ipv6 multicast destination-control

 Command: show ipv6 multicast destination-control [detail]

 show ipv6 multicast destination-control interface <Interfacename> [detail]

 show ipv6 multicast destination-control host-address <ipv6addr>

[detail]

 show ipv6 multicast destination-control <vlan-id> <mac> [detail]

 Function: Display IPv6 multicast destination control configuration.

 Parameters: detail: Whether to display detailed information.

 <Interfacename>: Interface name.

 <ipv6addr>: IPv6 address.

 <vlan-id> : VLAN ID.

 <mac>: MAC address.