Beurer JFT90 [27/140] Displaying saved measurements

Non-contact fever thermometer JFT 90

Hold the thermometer 2 to 3 cm from the measuring point. Press the

SCAN button and move the thermometer from side to side over the

forehead area (g. 8).

During measurement you will hear short beeps (only if the acoustic sig-

nal is activated), which signal that the thermometer has found a new

highest measurement.

End of measurement is signalled by a long beep.

Release the SCAN button.

You can now read the measured value.

In addition to the temperature, the fever

or no fever symbols also appear in the dis-

play:

The no fever symbol

indicates that the body temperature is within normal range; the

fever symbol

indicates a measurement of over 38 °C, i.e. temperature alarm.

The measuring time is usually 2 seconds but may take up to 30 seconds.

The device is ready to take another measurement when two short beeps sound and the

forehead symbol

stops ﬂashing.

The measurement is automatically saved with the date/time and the “fever”

“no fever”

classiﬁcation.

6.1 Displaying saved measurements

The device only stores measurements in forehead temperature mode . The device auto-

matically stores the values from the last 60 measurements.

When 60 storage places are exceeded the oldest value is deleted.

The memory can be called up as follows:

•

With the thermometer switched on, press and hold the MODE/MEM button for 5 seconds.

The most recent measurement is displayed.

•

With each subsequent pressing of the MODE/MEM button, ﬁrst the storage space num-

ber is displayed followed by the measurement upon release.

•

In the upper line, the time and date are displayed alternately.

Fig. 8