Ardo A1000X [63/88] How to remove stains

Ardo A1000X [63/88] How to remove stains
SM1
HOW TO REMOVE STAINS
Some stains cannot be removed by just washing in a washing machine. Before trying to
remove any type of stain by hand, first try the removal procedure on a small area of hidden
fabric starting from the edge of the stain and working inwards, this will prevent a dark ring
from forming around the site of the stain. A few methods for removing stains are reported
below.
WAX:
scrape the wax using a blunt point in order not to damage the fabric. Then, with
the fabric placed between two pieces of absorbent paper, run a hot iron over the
stain.
BALL-POINT PENS AND FELT-TIP PENS:
clean using a soft cloth soaked in ethyl alcohol.
Take care not to spread the mark.
DAMP AND MOULD:
if the fabric supports the use of bleach, perform a wash cycle
adding bleach to the appropriate compartment in the dispenser [see table of
programmes]. Otherwise, soak the soiled part in hydrogen peroxide (strength 10)
and leave for 10 to 15 minutes.
SCORCH MARKS CAUSED BY IRONING:
follow the instructions for mould and damp.
RUST:
use products specially designed for rust stains, following the manufacturer’s
instructions written on the packet.
CHEWING GUM:
rub ice over the mark, scrape away as much as possible and then rub
with a cotton cloth soaked in acetone (alternatively, use nail varnish remover).
PAINT:
do not allow the paint to dry. Rub the area with the solvent recommended by
Connecting to the mains electricity supply
Make sure that the voltage specified in the technical data,
written on the rating plate mounted on the inside of the
filter door, corresponds to the mains voltage [fig. 8].
Trip-switches, electric wiring and mains sockets must pos-
sess characteristics that enable them to support the maxi-
mum load indicated on the rating plate.
The mains socket to which the washing machine is con-
nected must be earthed. If not, the manufacturer will not be
held responsible for any incidents which may occur [fig. 9].
If the mains socket to which the washing machine is con-
nected does not work or is unsuitable, it must be replaced
by a qualified electrician.
The washing machine must not be connected to the mains
supply through intermediate devices such as extension
leads or multiple socket adapters.
During maintenance work, the washing machine plug must
be disconnected from the mains supply.
Never insert or remove the electric plug with wet hands.
If the power cable is damaged in any way, please contact
the technical service department.
Position the apparatus so that the plug can be accessed
and disconnected easily in case of need.
5

Содержание