HELMUT BSC350 Инструкция по эксплуатации онлайн [4/28] 496872

■ ALWAYS read, understand, and follow procedures in operator’s Manual before

attempting to operate equipment.

■ ALWAYS be sure to operator is familiar with proper safety precautions and

operating techniques before using the cutter.

■ Stop the engine when leaving the cutter unattended.

■ Block the unit when leaving or when using on a slope.

■ Maintain this equipment in a safe operating condition at all times.

■ ALWAYS stop the engine before serving, adding fuel and oil.

■ NEVER Run engine without air filter. Severe engine damage may occur.

■ ALWAYS service air cleaner frequently to prevent carburetor malfunction.

■ ALWAYS store equipment propped when it is not being used. Equipment should

be stored in a clean, dry location out of the reach of children.

■ NEVER operate this cutter in areas that contain combustible material or fumes.

Fire and/or explosions may result from errant sparks from the equipment.

WARNING:

■ DO NOT operate this equipment unless all guards and safety devices are

attached and in place.

Caution must be exercised while servicing this equipment. Rotating and moving parts can

cause injury if contacted.

■ Keep all inexperienced and unauthorized people away from the equipment at

all times.

■ Unauthorized equipment modifications will void all warranties.

DIAMOND BLADE SAFETY

■ Use appropriate steel centered diamond blades manufactured for use on

concrete cutters.

■ ALWAYS inspect diamond blades before each use. The blade should exhibit no

cracks, dings, or flaws in the steel centered core and/or rim. Center(arbor)hole must be

undamaged and true.

■ Examine blade flanges for damage, excessive wear and cleanliness before

mounting blade. Blade should fit snugly on the shaft and against the inside/outside blade

flanges.

■ Ensure that the blade is marked with an operating speed greater than the blade

shaft speed of the cutter.

■ Only cut the material that is specified by the diamond blade. Read the

specifications of the diamond blade to ensure the proper tool has been matched to the

material being cut.

■ AIWAYS keep blade guards in place. Exposure of the diamond blade must not

exceed 180 degrees.

■ Ensure that the diamond blade does not come into contact with ground or

surface during transportation. DO NOT drop the diamond blade on ground or surface.