HELMUT BSC350 Инструкция по эксплуатации онлайн [8/28] 496872

Hot Start-open the valve under the gas tank all the way if it has been shut off. Open the

throttle approximately half way. Do not apply the choke. Pull the starter rope sharply

until the engine starts. When the engine starts, adjust the throttle. Always operate the

engine at full throttle when under load.

NOTE: These starting instructions are general guidelines only. Since many engine options

are available, consult the Engine Manual included with this unit for specific instructions.

Caution-Gasoline Englnes-TO improve the engine service life, allow the engine to idle

without load for (2) to (5) minutes before shutting it down. When the idling period is up,

use the stop switch located on the engine and turn it to stop. Close the fuel valve under

the gas tank. Engine flooding can occur if the valve is left open during transport.

TO START CUTTING

1. Start engine and let engine warm up. All cutting is done at full throttle.

2. Align blade and cutter with cut. If wet cutting, open water valve and turn water

safety switch on.

3. Step on the left side of PEDAL until hear a “click”, then turn on the WHEEL

HANDLE on the top of the machine to remove the equipment forward and reverse, step

down the right side of PEDAL to change to “push” driving system.

4. Lower blade into cut slowly.

5. Cut as fast as blade will allow. If blade climbs out of cut, reduce forward speed

or depth of cut.

6. Use only enough side pressure on cutter handles to follow cutting line.

CUTTING

Lower the blade into concrete to required depth by turning the tilt crank

counterclockwise. Ease the saw slowly forward. Slow forward pressure if the saw begins

to stall.

Note: For deeper cuts(4 inches/102mm or more), several cuts should be made in

incremental steps of 1-1/2 inch (38mm) to 2 inches(51mm) until the desired depth is

reached.

Push the saw steadily forward using the front pointer as a guide. Exert enough forward

pressure so that the engine/motor begins to labor, but does not slow down. If the saw

begins to stall, retard forward movement until full RPM is restored to the blade. If saw

stalls, raise the blade out of the cut before restarting. Avoid excessive side pressure or

twisting of the blade in the cut.