HELMUT BSC350H Инструкция по эксплуатации онлайн [10/28] 496873

8. Misalignment will show up as a gap between the pulley face and straight edge.

Make sure there is clearance between arbor pulley and saw base on both sides.

DRY CUTTING

• Never operate any saw without safety guards in place.

• Do not exceed maximum operating speed established for blade diameter.

• Do not force blade into material: allow blade to cutat Its own speed.

• Do not make long continuous cuts. Never dry cut for more than 30 seconds

at s time. Allow blade to cool.

• Do not cut or grind with side of blade or cut a curve or radius. Do not cut dry

with blades recommended for wet cutting.

• Do not operate saw with blade diameter larger than machine’s capacity.

IV LUBRICATION AND SERVICE

• Check oil levels, wiring, hoses (air, fuel, water) and lubricate machine daily.

• Repair or replace all worn or damaged components immediately.

• Check drive belt tension, do not over-tension.

• Make sure machine has full set of matched belts.

• Check blade shaft, make sure arbor and threads are not worn, damaged, or

bent.

• Blade shaft bearings should be tight, no free play side-to-side or up and down.

• Grease blade shaft bearings daily.

• Blade collars should be clean, free of nicks and burrs. No diameter wear and not

out of round.

• Drive pin not excessively worn or bent and free of gouges.

• All guards in place and secure.

• All fasteners tight and secure.

• Air filter/oil filter (hydraulic or engine)clean.

• Flush clean water through the pump and spray the assembly every night. This

prolongs the pump and blade life.

These products are covered by warranty for a period of six (6) months from the date of

purchase against defects in material or workmanship provided that:

• The product concerned has been operated and maintained in accordance with

the operating instructions.

• Has not been damaged by accident, misuse or abuse.

• Has not been tampered with or repaired by any unauthorized person.

The owner is responsible for the cost of transportation to and from the authorized

repairer and the unit is at the owners risk while in transit to and from the repairer.

Lubricants:

- Engine oil SAE 10W/30

- General Grease #1 Lithium