Timberk TCH AB8 2000 [5/24] Delivery set

Timberk TCH AB8 800 [5/24] Delivery set
www.timberk.com • electric ceiling heater
5
1. Heater body
2. Protective grille
3. Heating element
4. Cover
5. Connection block
6. Rubber seal
1. Infrared heater – 1 pc.
2. Set of fasteners – 1 pc.
3. Operation manual – 1 pc.
4. Warranty certificate – 1 pc.
5. DELIVERY SET
Infrared heater mounting
1. Open the factory package and carefully remove the heater from it.
2. Take the set of fasteners.
3. Select the heater installation place on the ceiling or ceiling structural
elements with observation of minimum distances from objects and
minimum distance from the floor.
4. Install the brackets at distance from each other, securing them using a
chain or fasteners.
6. INSTALLATION
NOTE:
To improve the product quality, the design and
technical specifications of the infrared heater, as well
as its delivery set can be modified by the manufacturer
without preliminary notification.
WARNING!
Mounting of the infrared heater and its connection to the
electric mains should be carried out only by qualified
specialists according to the Electrical Installation
Regulations and Power System Safety Standards.
5. Suspend the heater on the brackets, first securing on edge, then
another. Make sure that screws are tightened firmly.
Connection to electric mains
1. The heater is designed for connection to the single-phase ~220 V, 50Hz
electric mains equipped with a grounding loop.
2. Before connection, make sure that specifications of the electric mains at the
connection point meet the parameters indicated on the appliance nameplate.
3. The heater should be connected to the electric mains using a cable with
wire section at least 1,5 mm
2
. The electric mains should be equipped with
an automatic circuit breaker with rated current 16 A.
4. For connection of the heater to the electric mains, it is necessary to do
the following:
remove the cover from the heater.
cut a hole in the rubber seal.
insert the electric cable to the heater.
tightly fix the bare ends of the electric cable in the junction block of the
heater with screws in strict correspondence with marking on the block.
reinstall the cover.
NOTE:
1. Depending on material and design of ceiling structural
elements, the heater is secured onto appropriate
fasteners chosen on basis of the strength condition.
Strength of the ceiling or structural elements, to which
the heater is secured, should be sufficient to endure
5-fold weight of the heater.
2. The heater can be installed on the wall and mounted
on the height not less than 1,8 from the floor. Also it
is obligatory to be installed an additional protection in
order to avoid the contact with heating plates.
WARNING!
After installation of the heater and before switching for
the first time, it is necessary to wipe the radiating board
with alcohol. After that, it is PROHIBITED to touch the
radiating board.

Содержание

Похожие устройства

Скачать