Dimplex Synergy — инструкция по установке камина: шаги и советы [15/24]
Макгруп McGrp.ru

Dimplex Synergy — инструкция по установке камина: шаги и советы [15/24]

Превью страниц Страница 15 / 24
Dimplex Synergy [15/24] Flush mounted installation 2x8 framing
15
Fireplace Installation
Figure 12
Mounting
hole
electric shock or injury to persons,
always use a licensed electrician.
Ensure that the On/Off Switch is set
to the Off position (refer to Opera-
tion section) and that the circuit on
which the replace is to be installed
has the power cut off at the service
panel until installation is complete.
3. Lift replace and insert into
opening (Figure 11).
4. Use bubble level (supplied) to
level the replace within the
framing. Adjust as required.
5. Drive four supplied mount-
ing screws through the four
mounting holes located in
each corner of the replace
chassis, into wall studs (Figure
12).
6. Refer to Front Glass Installa-
tion section, page 17 for nal
installation procedures.
Flush Mounted Installation
- 2x8 Framing
CAUTION: Two people may
be required for various steps
of this procedure.
1. Prepare a wall with a framed
opening of 49 in. (124.5 cm)
wide x 18½ in. (47 cm) high
(Figure 13).
!
NOTE: The sizing has al-
lowed for 1/4” (6.4mm) around the
replace insert for ease of instal-
lation. This replace does not
require any additional venting.
2. Choose your method of sup-
plying power to the unit:
Figure 13
2 x 8 Framing

Содержание

53

Похожие устройства

Узнайте, как правильно установить камин с помощью нашей пошаговой инструкции. Обеспечьте безопасность и правильное подключение к электросети.