Vitek VT-2349 [4/36] English
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Vitek VT-2349 [4/36] English

Vitek VT-2349 [4/36] English
4
ENGLISH
Attention! Do not allow children to play with poly-
ethylene bags or packaging film. Danger of suf-
focation!
•
Never pull the power cord when disconnecting
the unit from the mains; take the power plug and
carefully pull it out of the mains socket.
•
Never use the unit if the power cord or the power
plug is damaged, if the unit works improperly or
after it was dropped.
•
Do not attempt to repair the unit. Do not disas-
semble the unit by yourself, if any malfunction is
detected or after it was dropped, unplug the unit
and apply to any authorized service center from
the contact address list given in the warranty
certificate and on the website www.vitek.ru.
•
Transport the unit in the original package only.
•
Keep the unit out of reach of children and dis-
abled persons.
THIS UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY. ITS COMMERCIAL USAGE AND USAGE
IN PRODUCTION AREAS AND WORK SPACES IS
PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage at low tem-
perature keep it for at least three hours at room
temperature.
There may be water spots in the air humidifier,
this is normal, as the unit has undergone qual-
ity control.
–
Unpack the air humidifier, remove packaging
materials and any promo-stickers that can pre-
vent the unit operation. Check the unit for dam-
ages. Do not switch the air humidifier on in case
of damages.
–
Before plugging the unit in make sure that your
home mains voltage corresponds to the unit
operating voltage.
–
The unit is intended for operation in an AC power
network with the frequency of 50 Hz or 60 Hz, it
does not need any additional settings to operate
with the required nominal frequency.
Notes:
–
use the air humidifier at the room temperature
from +10°C to +40°C, and relative humidity less
than 80%.
–
water temperature should not exceed +40°C.
Installing batteries in the remote control (RC)
•
Open the RC battery compartment lid and insert
a CR2025 battery, strictly following the polarity.
•
Install the battery compartment lid back to its
place.
Note: The unit is supplied with the battery installed
in the RC battery compartment. If there is an isola-
tion insert in the RC battery compartment, remove
the insert.
Battery replacement
•
Open the battery compartment lid, replace
the old battery with a new one, strictly follow-
ing the polarity, then close the battery com-
partment lid.
USING THE AIR HUMIDIFIER
Notes:
–
the operation mode selection and setting but-
tons on the control panel (unlike the RC) are
sensory, you just need to touch the button to
switch the necessary operation mode on, every
touch of the active button is accompanied by a
sound signal.
–
for easy filling, the water tank (3) is equipped
with a detachable upper lid (1).
–
to remove the lid (1), pull it upwards by the ledge
in the rear part of the lid.
–
Remove the upper lid (1).
–
Fill the water tank (3) with the necessary amount
of water.
Attention!
Maximal capacity of the water tank is 6 l. To avoid
overflow, do not exceed the value set by the
manufacturer!
–
Install the lid (1) back to its place.
–
Wait for some time until the process chamber (7)
is filled with water.
–
If you want to use the aromatization function,
remove the aromatic oil container (4), add some
drops of water-soluble aromatic oil on the poly-
ester sponge and install the container (4) back
to its place.
Notes:
–
use water-soluble aromatic oils only.
–
if you are not going to use the aromatization
function, remove the polyester sponge from
the container (4), wash it and install back to its
place.
–
Insert the plug into the mains socket, you will
hear a sound signal and the unit will switch to the
standby mode.
–
Switch the unit on by touching the on/off but-
ton (13), you will hear a sound signal, and the
unit will switch on at maximal “mist” release
intensity. Current relative humidity digital sym-
bols (21), the symbols «%RH» and the “mist”
release intensity scale (20) will appear on the
display (5). The symbols «%RH» will be glow-
ing constantly.
–
You can adjust the “mist” release direction by
turning the nozzle (2) in various directions.
IM VT-2349.indd 4 7/30/20 11:59 AM

Содержание

Похожие устройства

Скачать