AXIOMET AX-DG1015AF Расширенная инструкция онлайн [10/15] 527979

• Set amplitude of channel A: set amplitude value at 1.5Vrms Select “Amplitude” by the corresponding soft key, then

press keys [1] [.] [5] and the soft key corresponding to [Vrms].

• Set offset of channel A: set DC offset at -1Vdc. Select “Offset” by the corresponding soft key, then press keys [-] [1]

and the soft key corresponding to [Vdc] .

• Select waveform of channel A: select arbitrary waveform

• Press key [Arb ].

• Select waveform of channel A: select square waveform

• Press key [Square ].

• Set duty ratio of channel A: set pulse duty ratio at 25%. Into the impedance menu, select “Duty” by the

corresponding soft key, then press the soft key corresponding to “duty ratio”, next press keys [2] [5] and the soft key

corresponding to [%].

4.6.2. Function of Channel B

• Press key [Channel] to select “CHB Alone”.

• Set frequency and amplitude of channel B: apply the same procedure of setting frequency and amplitude of channel B

as explained earlier.

• Select waveforms of channel B: select triangle wave Press the soft key corresponding to [Ramp ].

• Set harmonic wave of channel B: set frequency of channel B as a triple harmonic wave of channel A Into the wave

menu, select “Phase” by the corresponding soft key, press the soft key corresponding to “Harmonic”, then press key

[3] and the soft key corresponding to [Time].

• Set phase of channel B: set phase of channel B at 90°

• Into the wave menu, select “Phase” by the corresponding soft key, then press keys [9] [0] and the soft key

corresponding to [°].

4.6.3. Frequency Sweep

• Select “A SweepF” by the corresponding soft key.

• Set start frequency: set start frequency at 10kHz. Select “Start Freq” by the corresponding soft key, then press keys

[1] [0] [kHz].

• Set stop frequency: set stop frequency at 50kHz. Select “Stop Freq” by the corresponding soft key, then press keys

[5] [0] [kHz].

• Set sweep direction: set sweep direction at down sweep Select “Down Swe” by the corresponding soft key.

• Set the sweep mode: set the logarithmic sweep mode. select “Logarithmic” by the corresponding soft key

• Set sweep time: set sweep time at 25s Select “Sweep Time” by the corresponding soft key, then press keys [2] [5] [s].

• Set manual sweep: set the sweep at manual mode. Select “Manual Sweep” by the corresponding soft key. This

operation ceases the continuous sweep mode. Press key [CHA Output/Trigger] for one time, the frequency of

channel A will step up or down by one step.

4.6.4. Amplitude Sweep

Press key [Sweep] to select “A SweepA”. Apply the same setting procedure as described in section above.