MEAN WELL PM-05-5 Инструкция язык en онлайн

Installation Manual

 Type：Open Frame (PCB) Type Switching Power Supply

(Families: PM, NFM, IRM, MPS, MPD, MPT, MPQ, RPS, RPD, RPT, PS, PD, PT, PQ, PPS, PPT, PPQ, ASP, PID,

LPS, LPP, EPS, ELP, EPP)

 Introduction

An open frame (PCB) type switching power supply is a power supply designed to be integrated or installed into a

（2）At least 5mm insulation distance on the bottom of the unit should be kept and a Mylar film should be

added between the unit and the system. In addition, keep enough insulation distance, 10mm for

general type/15mm for medical type, around the unit.

（3）Power supplies greater than 120W may require a forced air/fan for cooling. Please refer to

specifications to receive a minimum air intensity and air-flow direction.

（4）Allow good ventilation for the unit in use to prevent it from overheating. Also, a 10-15 cm clearance

must be kept when the adjacent device is a heat source.

（5）Mounting orientations other than standard orientation or operate under high ambient temperature

may increase the internal component temperature and will require a de-rating in output current.

Please refer to the specification sheets to receive the optimum mounting position and information

（7）For other information about the products, please refer to www.meanwell.com for details.

 Warning / Caution !!

（5）The ground (FG) must be connected to earth ground.

（6）All MW’s PSUs are designed in accordance with EMC regulations and the related test reports are

available by request. Since they are belong to component power supplies and will be installed inside

system enclosure, when they are integrated into a system, the EMC characteristics of the end

system must be re-verified again.