MEAN WELL HLN-40H-54B Datasheet онлайн
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH℃
CONSTANT CURRENT REGION
Note.4
HLN-40H-12
A
B : IP64 rated. Constant current level adjustable through output cable with 1~10Vdc or 10V PWM signal or resistance.
SPECIFICATION
MODEL
DC VOLTAGE
RATED CURRENT
RATED POWER
OUTPUT
VOLTAGE ADJ. RANGE
Note.6
CURRENT ADJ. RANGE
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME
Note.7
HOLD UP TIME (Typ.)
VOLTAGE RANGE
Note.5
FREQUENCY RANGE
POWER FACTOR (Typ.)
EFFICIENCY (Typ.)
AC CURRENT (Typ.)
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
SAFETY STANDARDS
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVER CURRENT
Note.4
OVER VOLTAGE
OVER TEMPERATURE
Can be adjusted by internal potentiometer A type only
16ms/230VAC 16ms/115VAC at full load
90 ~ 305VAC 127 ~ 431VDC
47 ~ 63Hz
PF>0.98/115VAC, PF>0.95/230VAC, PF>0.92/277VAC at full load (Please refer to "Power Factor Characteristic" curve)
0.43A / 115VAC 0.24A / 230VAC 0.23A / 277VAC
COLD START 50A(twidth=210 s measured at 50% Ipeak) at 230VACμ
<0.75mA / 277VAC
95 ~ 108%
Protection type : Constant current limiting, recovers automatically after fault condition is removed
-40 ~ +50 (Refer to "Derating Curve")℃
20 ~ 95% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH℃
±℃ ℃0.03%/ (0 ~ 40 )
10 ~ 500Hz, 2G 12min./1cycle, period for 72min. each along X, Y, Z axes
UL8750, CSA C22.2 No. 250.0-08 (except for 48V, 54V), EN61347-1, EN61347-2-13 independent, IP64, J61347-1, J61347-2-13
approved ; design refer to UL60950-1, TUV EN60950-1, EN60335-1
336.5Khrs min. MIL-HDBK-217F (25 )℃
161*61.5*35mm (L*W*H)
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.℃
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Please refer to "DRIVING METHODS OF LED MODULE".
5. Derating may be needed under low input voltages. Please check the static characteristics for more details.
6. A type only.
7. Length of set up time is measured at cold first start. Turning ON/OFF the power supply may lead to increase of the set up time.
8. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
9. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED power supply can only be used behind a switch without permanently
connected to the mains.
0.35Kg;32pcs/12.2Kg/1.10CUFT
Protection type : Shut down o/p voltage, re-power on to recover
40W Single Output Switching Power Supply
Universal AC input / Full range (up to 305VAC)
Built-in active PFC function
Protections: Short circuit / Over current / Over voltage / Over temperature
Cooling by free air convection
OCP point adjustable through output cable or internal potentiometer
Fully isolated plastic case with IP64 level
Class 2 power unit
Three in one dimming function (1~10Vdc or PWM signal or resistance)
Suitable for LED lighting and moving sign applications
Compliance to worldwide safety regulations for lighting
Suitable for dry / damp locations or outdoor application
3 years warranty
■ Features :
HLN-40H series
RIPPLE & NOISE (max.) Note.2
VOLTAGE TOLERANCE Note.3
ENVIRONMENT
SAFETY &
EMC
PROTECTION
Shut down o/p voltage, re-power on to recover
SELV
IP64
A : IP64 rated. Output voltage and constant current level can be adjusted through internal potentiometer.
FMM
110
86.5%
86.5%
87.5%
88%
88.5%
88.5%
89%88.5% 89%
2 ~ 3.33A 1.6 ~ 2.67A 1.2 ~ 2A 1 ~ 1.67A 0.8 ~ 1.34A
0.67 ~ 1.12A
0.5 ~ 0.84A 0.45 ~ 0.75A
0.58 ~ 0.96A
12V
HLN-40H-12 HLN-40H-15 HLN-40H-20 HLN-40H-24 HLN-40H-30 HLN-40H-36 HLN-40H-42 HLN-40H-48 HLN-40H-54
7.2 ~12V
15V
9 ~ 15V
20V
12 ~ 20V
24V
14.4 ~ 24V
30V
18 ~ 30V
36V
21.6 ~ 36V
48V
28.8 ~ 48V
3.33A 2.67A 2A 1.67A
1.34A
1.12A
0.84A
40W 40W 40W 40.1W 40.2W
40.3W
40.3W
150mVp-p 150mVp-p
13.5 ~ 17V
150mVp-p
17 ~ 22V
150mVp-p
22 ~ 27V
200mVp-p
27 ~ 33V
200mVp-p
33 ~ 40V
300mVp-p
44 ~ 53V10.8 ~ 13.5V
54V
32.4 ~ 54V
0.75A
40.5W
300mVp-p
49 ~ 58V
42V
25.2 ~ 42V
0.96A
40.3W
300mVp-p
40 ~ 46V
±2.5% ±2.0% ±1.0% ±1.0% ±1.0%
±1.0%
±1.0%
±0.5% ±0.5% ±0.5% ±0.5% ±0.5%
±0.5%
±0.5%
±2.0%
±1.5% ±1.0% ±0.5% ±0.5%
±0.5%
±0.5%
±1.0%
±0.5%
±0.5%
±1.0%
±0.5%
±0.5%
18 ~ 24V15 ~ 21V 23 ~ 30V
28 ~ 35V
35 ~ 43V
41 ~ 49V
48 ~ 58V 59 ~ 68V
54 ~ 65V
Compliance to EN55015, EN61000-3-2 Class C ( 60% load) ; EN61000-3-3≧
Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, EN55024, light industry level (surge 4KV), criteria A
EMC IMMUNITY
EMC EMISSION
( except for 48V,54V )( for 48V,54V only)
SHORT CIRCUIT
Hiccup mode, recovers automatically after fault condition is removed
File Name:HLN-40H-SPEC 2014-08-14
500ms, 80ms at full load 230VAC / 115VAC
Содержание
- Hiccup mode recovers automatically after fault condition is removed 1
- Hln 40 1
- Series 1
- W single output switching power supply 1
- Block diagram 2
- Hln 40 2
- Mechanical specification 2
- Series 2
- W single output switching power supply 2
- 20 30 40 50 60 70 80 90 100 3
- Constant current mode 3
- Hln 40 3
- Series 3
- W single output switching power supply 3
- Dimming operation for b type only 4
- Driving methods of led module 4
- Hln 40 4
- Series 4
- W single output switching power supply 4
- Dimming connection diagram for turning the lighting fixture on off 5
- Direct connecting to leds is suggested but is not suitable for using additional drivers 5
- Hln 40 5
- Output constant current level can be adjusted through output cable by connecting a or 1 10vdc or 10v pwm signal between dim and dim resistance 5
- Series 5
- The led lighting fixture can be turned on off by the switch 5
- Using a switch and relay can turn on off the lighting fixture 5
- Using the built in dimming function on b type model can t turn the lighting fixture totally dark please refer to the connection method below to achieve 0 brightness of the lighting fixture connecting to the led power supply unit 5
- W single output switching power supply 5
Похожие устройства
- MEAN WELL HLN-40H-54B Документация
- MEAN WELL HLN-60H-15B Инструкция по эксплуатации
- MEAN WELL HLN-60H-15B Инструкция язык EN
- MEAN WELL HLN-60H-15B Datasheet
- MEAN WELL HLN-60H-15B Документация
- MEAN WELL HLN-60H-24A Инструкция по эксплуатации
- MEAN WELL HLN-60H-24A Инструкция язык EN
- MEAN WELL HLN-60H-24A Datasheet
- MEAN WELL HLN-60H-24A Документация
- MEAN WELL HLN-60H-30A Инструкция по эксплуатации
- MEAN WELL HLN-60H-30A Инструкция язык EN
- MEAN WELL HLN-60H-30A Datasheet
- MEAN WELL HLN-60H-30A Документация
- MEAN WELL HLN-60H-30B Инструкция по эксплуатации
- MEAN WELL HLN-60H-30B Инструкция язык EN
- MEAN WELL HLN-60H-30B Datasheet
- MEAN WELL HLN-60H-30B Документация
- MEAN WELL HLN-60H-36A Инструкция по эксплуатации
- MEAN WELL HLN-60H-36A Инструкция язык EN
- MEAN WELL HLN-60H-36A Datasheet