![MEAN WELL XLG-25-AB [2/8] Series](/img/pdf.png)
MEAN WELL XLG-25-AB [2/8] Series
![MEAN WELL XLG-25-AB [2/8] Series](/views2/1705961/page2/bg2.png)
SPECIFICATION
MODEL
OUTPUT
VOLTAGE RANGE
Note.5
FREQUENCY RANGE
POWER FACTOR
EFFICIENCY (Typ.)
Note.10
AC CURRENT
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
EMC IMMUNITY
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP.
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
500ms, 100ms/115VAC, 230VAC
47 ~ 63Hz
0.29A / 115VAC 0.15A / 230VAC 0.13A/277VAC
<0.75mA / 277VAC
20 ~ 95% RH non-condensing
-40 ~ +80℃
±℃ ℃0.03%/ (0 ~ 60 )
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
105 63**30mm (L*W*H)
ENVIRONMENT
EMC EMISSION
SAFETY &
EMC
PROTECTION
I/P-O/P:3.75KVAC I/P-FG:2.0KVAC O/P-FG:1.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH℃
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
88%
TOTAL HARMONIC DISTORTION
RATED CURRENT
RATED POWER
Note.5
CURRENT ADJ. RANGE
SETUP, RISE TIME
Note.3
OPEN CIRCUIT VOLTAGE (max.)
CONSTANT CURRENT REGION
Note.2
SAFETY STANDARDS
COLD START 50A(twidth=350 s measured at 50% Ipeak) at 230VACμ;Per NEMA 410
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
5 units (circuit breaker of type B) / 8 units (circuit breaker of type C) at 230VAC
MAX. CASE TEMP.
Tcase=+85℃
Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level ( )surge immunity Line-Earth 6KV, Line-Line 4KV
(Please refer to "STATIC CHARACTERISTIC" section)
90 ~ 305VAC
1. All parameters NOT specially mentioned are measured at 230VAC input, rated and 25 of ambient temperature.current ℃
2. Please refer to "DRIVING METHODS OF LED MODULE".
3. Length of set up time is measured at first cold start. Turning ON/OFF the driver may lead to increase of the set up time.
4. De rating may be needed under low input voltages. Please .- refer to STATIC CHARACTERISTIC sections for details
5. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6. This series meets the typical life expectancy of >50,000 hours of operation when Tcase, particularly tc point (or TMP, per DLC), is about 70 or less.℃
7. Please refer to the warranty statement on MEAN WELL's website at http://www.meanwell.com
8. Only for XLG-25 I series
9. The ambient temperature derating of 3.5 /1000m with fanless models and of 5 /1000m with fan models for operating altitude higher than 2000m(6500ft).℃℃
10. Only for XLG-25-A
11. For any application note and IP water proof function installation caution, please refer our user manual before using.
https://www.meanwell.com/Upload/PDF/LED_EN.pdf
110-150% Over Power Protection, recovers automatically after fault condition is removed
Constant current limiting, recovers automatically after fault condition is removed
PF 0.97/115VAC, PF 0.95/230VAC, PF 0.92/277VAC@full load≧≧≧
(Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section)
THD< 10%(@load 50%/115VC,230VAC; @load 75%/277VAC)≧≧
(Please refer to “TOTAL HARMONIC DISTORTION(THD)” section)
No load power consumption <0.5W for A,<0.75W for I series
NO LOAD / STANDBY
POWER CONSUMPTION
Standby power consumption <0.5W for AB
Tcase=-40 ~ +85 (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section)℃
UL8750 ENEC AS/NZS IEC EN61347-1, AS/NZS EN61347-2-13 independent, EN62384;(type”HL”), CSA C22.2 No. 250.13-12;
IP65 or IP67; approvedGB19510.1, GB19510.14
Compliance to EN55015,EN61000-3-2 Class C (@load 50%) ; EN61000-3-3;≧ GB17743, GB17625.1
1305.62 K hrs min. Telcordia SR-332 (Bellcore) 399.88Khrs min. MIL-HDBK-217F (25 )℃
XLG-25
0.25 ~ 1.05A
22 ~54V
25W
700mA
90VAC ~ 305VAC
File Name:XLG-25-SPEC 2018-11-16
57V
5.0% @max. rated current
CURRENT RIPPLE
OVER TEMPERATURE
Hiccup mode, recovers automatically after fault condition is removed
INPUT OVER VOLTAGE
Note.8
320 ~ 370 (Shut down output voltage when the input voltage exceeds protection voltage)VAC
can survive input voltage stress of 440Vac for 48 hours
SHORT CIRCUIT
OVER POWER
0.41Kg;24pcs/ 10.5Kg/0.68CUFT for A-type 0.42Kg;24pcs/ 11Kg/0.68CUFT for AB-type
25W Constant Power Mode LED Driver
XLG-25 series
Содержание
- Series 1
- Series 2
- Specification 2
- W constant power mode led driver 2
- Block diagram 3
- Driving methods of led module 3
- Series 3
- W constant power mode led driver 3
- Dimming operation 4
- Output current 4
- Series 4
- W constant power mode led driver 4
- 20 30 40 50 60 70 80 90 100 5
- 72 74 76 78 80 82 84 86 88 90 92 5
- Series 5
- Static characteristic 5
- W constant power mode led driver 5
- Life time 6
- Series 6
- W constant power mode led driver 6
- Series 7
- W constant power mode led driver 7
- Series 8
- W constant power mode led driver 8
Похожие устройства
- ШТРИХ–М СМАРТПОС-Ф Инструкция по эксплуатации
- ШТРИХ–М СМАРТПОС-Ф Общее руководство по настройке ККТ
- ШТРИХ–М СМАРТПОС-Ф Быстрый старт
- MEAN WELL XLG-50-A Инструкция по эксплуатации
- MEAN WELL XLG-50-A Каталог
- MEAN WELL XLG-50-A Инструкция язык en
- MEAN WELL XLG-50-A Datasheet
- ШТРИХ–М НАНО-Ф Обновление ПО ККТ
- ШТРИХ–М НАНО-Ф Быстрый старт
- ШТРИХ–М НАНО-Ф Инструкция по подключению ФР Штрих_М к 1С
- MEAN WELL XLG-50-AB Инструкция по эксплуатации
- MEAN WELL XLG-50-AB Инструкция язык en
- MEAN WELL XLG-50-AB Каталог
- MEAN WELL XLG-50-AB Datasheet
- ШТРИХ–М ON-LINE Инструкция по эксплуатации
- ШТРИХ–М ON-LINE Общее руководство по настройке ККТ
- ШТРИХ–М ON-LINE Инструкция по подключению ФР Штрих_М к 1С
- ШТРИХ–М ЭЛВЕС-ФР-Ф Инструкция по эксплуатации
- ШТРИХ–М ЭЛВЕС-ФР-Ф Общее руководство по настройке ККТ
- ШТРИХ–М ЭЛВЕС-ФР-Ф Инструкция по подключению ФР Штрих_М к 1С