Gorenje G640X [44/48] Servicing

SERVICING

Always disconnect the appliance from the

electricity and gas mains before proceeding

with any servicing operation.

11) REPLACING HOT PLATE PARTS

When parts housed within the hot plate need

replacing, it is first necessary to remove the hot

plate itself from the cabinet, to overturn it, unscrew

screws “V” and to remove part (see fig. 14).

After having carried out the above listed operations,

the burners (fig. 15), taps (fig. 16) and electrical

components can all be replaced (fig. 17).

It is advisable to change seal “D” whenever a tap is

replaced to ensure a perfect tightness.

Greasing the taps (see fig. 18 - 19)

If a tap becomes stiff to operate, it must be

immediately greased in compliance with the

following instructions:

- remove the tap.

- Clean the cone and its housing using a cloth

soaked in diluent.

- Lightly spread the cone with the relative grease.

- Fit the cone back in place, operate it several times

and then remove it again. Eliminate any excess

grease and check that the gas ducts have not

become clogged.

- Fit all parts back in place, complying with the

demounting order in reverse.

- Check the tightness by using soapy water. The

use of the flame is prohibited.

To facilitate the servicing technician’s task, here is a

chart with the types and sections of the powering

cables and the ratings of the electrical components.

FIG. 17 FIG. 18 FIG. 19

FIG. 14 FIG. 15 FIG. 16