Cecotec Conga 1590 Active Инструкция по эксплуатации онлайн [31/71] 549077

ENGLISH

if necessary until it nishes it. Once it has completed cleaning, the robot will operate in

Random mode until it runs out of battery.

2. Edge mode: the display will show MODE 1, the robot will clean along the edges and will

return to the charging base through its smart technology once it has nished. If there is

no charging base, the robot will return to the starting point.

3. Area mode: the display will show MODE 2 and the robot will clean a 2*2 m area.

4. Random mode: the display will show MODE 3, will start cleaning randomly and then will

return to the charging base with its smart technology once it runs out of battery. The

robot will not create any map under this mode.

5. Twice mode: the display will show MODE 4, the robot will carry out a whole cleaning cycle

following the next pattern: Gyro mode, Edge mode, Gyro mode and Edge mode again.

When the cycle is completed, it will return to the charging base with its smart technology.

6. Scrubbing mode: Press the button to enter the water-intensity mode and select

the desired intensity and select between 1, 2 or 3 (see WATER INTENSITY/TIME SETTINGS

section). The display will show MODE 6. With this mode, the robot will carry out a cleaning

cycle in Gyro mode and in Edge mode, moving forward 2 metres and then backwards 1

metre consecutively, simulating a real scrubbing movement. It will return to the charging

base if necessary to nish cleaning, and nally will return to the charging base when it

runs out of battery. You can select the desired water intensity level: high, medium or low.

• Do not use the mop outdoors.

• Remove the carpets before operating the robot under this mode.

• During operation, control the water level on the Wet&dry tank. If it empties, ll it up

again before continuing scrubbing.

• Take the Wet&dry tank and the mop out before charging the robot.

Note: in order to ensure perfect scrubbing, moisten the mop before starting scrubbing.

7. Gyro mode: When this mode is activated, the robot

willcarry out a whole cleaning cycle in Gyro mode and then

in Edge mode. The display will show MODE 5. Once it has

nished, it will automatically return to the charging base. If it

has not started the cleaning cycle form the charging base, it

will return to the starting point.

Note: If the room being cleaned is smaller than 10 m2, the robot will carry out the same cycle

twice.

8. Manual mode

• Use the direction buttons to take the robot to the specic points where you want it

to clean.

9. Back home mode

• This mode can be selected at any point of any cleaning cycle. Once it is activated,