SilverStone ST75F-PT [5/12] Manual st75f pt p186 _st65f pt p187 _st55f pt p188 v1 3
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

SilverStone ST75F-PT [5/12] Manual st75f pt p186 _st65f pt p187 _st55f pt p188 v1 3

SilverStone ST65F-PT [5/12] Manual st75f pt p186 _st65f pt p187 _st55f pt p188 v1 3
03
3.2 Remote On/Off Controlled mode
The PSON# signal is required to remotely turn on/off the power supply, PSON# is an active low signal that
turns on the output power rails. When this is not pulled low by the system, or left open, the outputs (except
the +5VSB) turn off. This signal is pulled to a standby voltage by a pull-up resistor internal to the power
supply.
TTL level "H" 2.0 V – 5.25 V
"L" 0.0 V – 1.0 V
ST65F-PT
Maximum continuous total DC output power should not exceed650W.
Maximum continuous combined load on +3.3VDC and +5VDC outputs shall not exceed 120W.
Maximum combined load on +12V outputs shall not exceed 650W.
NOTE:
Noise test should be measured with 20 MHz bandwidth frequency oscilloscope. The output terminal shall
add a tantalum capacitor of 10uF in parallel with a ceramic capacitor of 0.1uF.
Output Voltage
1. +5V
2. +12V
4. –12V
5. +5Vs
6. +3.3V
Load MIN
0.0A
0.0A
0.0A
0.0A
0.0A
Range MAX
22A
54.2A
0.3A
3.0A
22.0A
Regulation
±3%
±3%
±10%
±5%
±53%
Ripple & Noise P-P Max.
50mV
120mV
120mV
50mV
50mV
ST55F-PT
Maximum continuous total DC output power should not exceed550W.
Maximum continuous combined load on +3.3VDC and +5VDC outputs shall not exceed 105W.
Maximum combined load on +12V outputs shall not exceed 550W.
NOTE:
Noise test should be measured with 20 MHz bandwidth frequency oscilloscope. The output terminal shall
add a tantalum capacitor of 10uF in parallel with a ceramic capacitor of 0.1uF.
Output Voltage
1. +5V
2. +12V
4. –12V
5. +5Vs
6. +3.3V
Load MIN
0.0A
0.0A
0.0A
0.0A
0.0A
Range MAX
20A
45.9A
0.3A
3.0A
20.0A
Regulation
±3%
±3%
±10%
±5%
±3%
Ripple & Noise P-P Max.
50mV
120mV
120mV
50mV
50mV

Содержание

Похожие устройства

Скачать