SilverStone ST75F-PT [7/12] Manual st75f pt p186 _st65f pt p187 _st55f pt p188 v1 5

SilverStone ST65F-PT [7/12] Manual st75f pt p186 _st65f pt p187 _st55f pt p188 v1 5
05
3.7 PG-OK
3.8 3.3V Sense
PG-OK is a power good signal and should be asserted high by power supply to indicate that the +5 VDC
and +3.3 VDC outputs are above the under-voltage thresholds of the power supply. When this signal is
asserted high, there should be sufficient mains energy stored by the converter to guarantee continuous
power operation within specification. Conversely, when either the +5VDC or the +3.3VDC output voltage
falls below the under-voltage threshold, or when mains power has been removed for a time sufficiently
long so that power supply operation is no longer guaranteed, PG-OK should be deasserted to a low state.
See Figure 1 for a representation of the timing characteristics of the PG-OK,PS-ON, and germane power
rail signals.
A default 3.3V sense line should be implemented pin 13 of the connector.
3.9 Capacitive Load
The power supply should be able to power up and operate normally with the following capacitances
simultaneously present on the DC outputs.
In primary circuit of the power supply , a protected fuse is inserted. Only internal fault of the power supply
will cause the fuse blown. Any overload or short circuit at DC output will keep from fuse brown or fire hazard.
4.1 Input Protection
The +5V/+12V/+3.3V DC output are protected against the under voltage condition . range value can't
be exceed 3.3~3.7V at 5V terminal and 8.5~9.5V at 12V, 2.0~2.4V at 3.3V.
4.2 Output Protection
4.2.1 Under voltage protection
The +12V/ DC output are protected against the over voltage condition . Maximum value can't be over
15.5V at 12V.
4.2.2 Over Voltage Protection
The power supply can be used electronic circuit to limit the output current against exceeding 10%-60%
of surge output power or protected against excessive power delivery since short circuit of any output
or over total power at high line.
4.2.3 Over Power Protection
Output
+5V
+12V
+3.3V
-12V
+5VS
Capacitive load (uF)
6,000
8,000
6,000
350
350
4. Protection

Содержание

Скачать