![Icom IC-F70DT [34/48] Battery charging](/img/pdf.png)
Icom IC-F70DT [34/48] Battery charging
![Icom IC-F80DT [34/48] Battery charging](/views2/1074205/page34/bg22.png)
30
5
BATTERY CHARGING
■ Battery charging
Prior to using the transceiver for the first time, the battery
pack must be fully charged for optimum life and operation.
CAUTION: To avoid damage to the transceiver, turn the
power OFF while charging.
• Recommended temperature range for charging:
+10°C to +40°C (+50°F to +104°F)
• Use the specified chargers (BC-119N and BC-121N).
NEVER use another manufacture’s charger.
• Use the specified AC adapter. NEVER use another manu-
facture’s adapter.
■ Battery caution
R DANGER Charge the specified Icom batteries only.
Only tested and approved for use with genuine Icom batter-
ies. Fire and/or explosion may occur when a third party bat-
tery pack or counterfeit product is charged.
CAUTION! NEVER insert battery pack/transceiver (with the
battery pack attached) in a wet or soiled condition into the
charger. This may result in corrosion of the charger terminals
or damage to the charger. The charger is not waterproof and
water can easily get into it.
NEVER incinerate used battery packs. Internal battery gas
may cause an explosion.
NEVER immerse the battery pack in water. If the battery
pack becomes wet, be sure to wipe it dry BEFORE attaching
it to the transceiver.
NEVER short the terminals of the battery pack. Also, current
may flow into nearby metal objects, such as a necklace, etc.
Therefore, be careful when carrying with, or placing near
metal objects, carrying in handbags, etc.
AVOID leaving the battery pack in a fully charged, or completely
discharged condition for long time. It causes shorter battery life.
In case of leaving the battery pack unused for a long time, it
must be kept safely after discharge, or use the battery until the
battery indicator appears, then remove it from the transceiver.
If your battery pack seems to have no capacity even after
being charged, fully charge the battery pack again. If the bat-
teries still do not retain a charge (or very little), new battery
pack must be purchased.
Recommendation:
Charge the supplied battery pack for a maximum of
up to 10 hours. Li-Ion batteries are different from Ni-
Cd batteries in that it is not necessary to completely
charge and discharge them to prolong the battery life.
Therefore, charging the battery in intervals, and not
for extended periods is recommended.
IC-F70_F80-1.qxd 05.1.18 4:26 PM Page 30 (1,1)
Содержание
- About apco project 25 2
- Explicit definitions 2
- Important 2
- Read all instruction 2
- Save this instruction manual 2
- Be careful 3
- Precautions 3
- R caution neve 3
- Table of contents 4
- Accessories 5
- I accessory attachments 5
- I supplied accessories 5
- Accessories 6
- D belt clip 6
- Ï battery pack 6
- Accessories 7
- Ï connector cover 7
- I front panel 8
- Panel description 8
- Panel description 9
- I function display 10
- Panel description 10
- Q t o i u y r e w 10
- I programmable function keys 11
- Panel description 11
- Panel description 12
- Panel description 13
- Panel description 14
- D for digital mode operation only 15
- Panel description 15
- Basic operation 16
- I channel selection 16
- I turning power on 16
- Basic operation 17
- I call procedure 17
- I receiving and transmitting 17
- Basic operation 18
- D transmitting notes 18
- D tx code channel selection 18
- Basic operation 19
- D tx code number edit 19
- Basic operation 20
- D dtmf transmission 20
- D individual id code selection 20
- D talkgroup id code selection 20
- Basic operation 21
- I user set mode 21
- Basic operation 22
- I scrambler function 22
- Biis operation 23
- I default setting 23
- I receiving a call 23
- Biis operation 24
- D displaying the received call record queue indication 24
- D group call 24
- Note only one station is permitted to speak e release ptt to return to receive 24
- Q push and hold p1 digital for 1 sec 24
- Q when a group call is received 24
- R to finish the conversation push monitor moni audi to send the clear down signal 24
- The transceiver memorizes the calling station id in the mem ory up to 3 calls can be memorized and the oldest call record is erased when a 4th call is received however once the transceiver is powered off the all records are cleared 24
- W push and hold ptt then speak into the microphone at a normal voice level 24
- W push up or down to select the desired call e push and hold p1 digital for 1 sec again to return to the standby condition 24
- When a record is available 24
- When no record is available 24
- Biis operation 25
- D calling back from the queue channel 25
- D using call memory 25
- I transmitting a call 25
- Biis operation 26
- D direct code entry 26
- Biis operation 27
- D receiving a status message 27
- D receiving an sdm short data message 27
- I receiving a message 27
- Biis operation 28
- D received message selection 28
- Biis operation 29
- D general 29
- D transmitting a status 29
- I transmitting a status 29
- Biis operation 30
- D general 30
- D programming an sdm memory 30
- D transmitting an sdm 30
- I transmitting an sdm 30
- Short data message 30
- Biis operation 31
- I position data transmission 31
- Biis operation 32
- I auto emergency transmission 32
- I digital ani 32
- I printer connection 32
- I stun function 32
- Biis operation 33
- I biis indication 33
- I priority a channel selection 33
- Battery charging 34
- Caution neve 34
- I battery caution 34
- I battery charging 34
- R dange 34
- Battery charging 35
- I optional battery chargers 35
- Ï ad 110 installation 35
- Ï rapid charging with the bc 119n ad 110 35
- Battery charging 36
- Ï rapid charging with the bc 121n ad 110 36
- Battery case 37
- I optional battery case bp 237 37
- I mb 93 contents 38
- I to attach 38
- Swivel belt clip 38
- Caution 39
- I to detach 39
- Swivel belt clip 39
- I attachment 40
- I optional hm 138 description 40
- Speaker microphone 40
- D battery pack 41
- D belt clips 41
- D chargers 41
- D dc cables 41
- D optional units 41
- Options 41
- D other options 42
- Options 42
- Ï about vs 1sc 42
- Options 43
- Safety training information 44
- Safety training information 45
- 1 32 kamiminami hirano ku osaka 547 0003 japan 48
Похожие устройства
- Toshiba P875-BMS Инструкция по эксплуатации
- Эван WARMOS-QX 18 Инструкция по эксплуатации
- Icom IC-F80T Инструкция по эксплуатации
- Samsung NP700G7A-S03RU Инструкция по эксплуатации
- Эван WARMOS-QX 22.5 Инструкция по эксплуатации
- HP Mini 200-4251sr Инструкция по эксплуатации
- Icom IC-F80DT Инструкция по эксплуатации
- Эван WARMOS-QX 27 Инструкция по эксплуатации
- Icom IC-F9011 Инструкция по эксплуатации
- Samsung NP535U4C-S02RU Инструкция по эксплуатации
- Эван WARMOS 9.45 Инструкция по эксплуатации
- Icom IC-F1821 Инструкция по эксплуатации
- Prestigio PMP5097CPRORU Инструкция по эксплуатации
- Эван WARMOS 12 Инструкция по эксплуатации
- Icom IC-F5021 Инструкция по эксплуатации
- Acer A200 16Gb Red Инструкция по эксплуатации
- Эван WARMOS 15 Инструкция по эксплуатации
- Icom IC-F6021 Инструкция по эксплуатации
- Acer A200 16Gb Titanium Инструкция по эксплуатации
- Эван WARMOS 18 Инструкция по эксплуатации