Vitek VT-3478 OG [5/40] English

Vitek VT-3478 BK [5/40] English

5
2. Headphones jack
25. Plug

26. CD Button
27. USB Button
28. PLAY MOD Button
29. PROG Button
30. < STOP Button
3. 4; PLAY/PAUSE Button
32. 9 SKIP BACK Button
33. : SKIP NEXT Button
3. 6ALBUM DOWN Button
35. 5 ALBUM UP Button
36. TRACK -0 Button
37. TRACK +0 Button

The battery is pre-installed in the remote control
with the insulation plate. Before starting to
operate the remote control, please pull out the
insulation plate from the battery compartment.

Note: Do not attempt to recharge, short-circuit,
disassembly, heat or throw the batteries into
the fire. If the remote control doesn’t work or
the signal gets weaker, the battery might get
weaker. In that case, please replace the battery.
. Pull out the battery holder as shown right.
2. Place one battery (CR 2025) as shown right.
Make sure that the polarity (+/-) of battery
matches the marks inside the unit.
3. Insert the battery holder into its
compartment as shown right.


. Insert the net cable in the jack (25), then put
the plug in the socket.
Change the position of FUNCTION (22) to the
required sound position (RADIO, CD, TAPE).
2. To switch off change the position of FUNCTI-
ON (22) to TAPE (OFF).


After you have found the required station, adjust
the volume using VOLUME ().

Press BBS button (9), to get good sound of low
frequencies.

. Set FUNCTION (22) at RADIO position.
2. Choose by means of BAND switch (2) AM or
FM or FM.ST range.
3. Use TUNING (7) to adjust to the required
station.
. After you have finished listening to the radio
set FUNCTION (22) at the position TAPE
(OFF) .

. Set FUNCTION (22) at CD position
2. If there is no CD in the CDslot or a CD is
damaged the indicator “no” will appear on
the LCD.

. Use latch of the CD disc slot to open CD disc
slot.
2. Set the disc. There will be the table of con-
tent.
Note: be sure that the disc is fixed in the slot.
After the table of content is counted
Note: this appliance is for CDR /CDRW for-
mats.
3478.indd 5 17.04.2007 14:47:57

Содержание