Vitek VT-2212 [5/34] English

Vitek VT-2212 [5/34] English
5
ENGLISH
Battery installation and replacement
Make sure that the operation mode switch (9) is set to
the position “0”.
Remove the battery compartment lid (13) and insert
or replace 2 AA batteries, strictly following the po-
larity.
Install the battery compartment lid (13) back to its place.
Notes: If there is an isolation insert in the battery compart-
ment, remove the battery compartment lid (13), remove the
isolation insert and install the battery compartment lid (13)
back to its place.
USAGE
Make sure that the operation mode switch (9) is set to
the position 0”.
Please note that the unit is powered by batteries only.
Before using the unit check whether the batteries are
installed in the battery compartement.
Install the required attachment (2-7) on the installation
place (11).
We recommend to use:
• coarse disc (7) to shape your nails;
• fine disc (2) to finish shaping your nails;
• small cylindrical attachment (3) to treat skin around the
nails and to remove cuticles;
• felt disc (4) for polishing the nail edge and surface and
adding gloss to your nails;
• large cone attachement (5) to remove rough skin;
• small cone attachement (6) to treat nails;
Use the operation mode switch (9) to set the required
attachment rotation speed:
«0» – the unit is off;
«R1» low speed, attachment rotates to the right, the
illumination (12) lights up;
«R2» high speed, attachment rotates to the right, the
illumination (12) lights brighter;
«L1» low speed, attachment rotates to the left, the illu-
mination (12) lights up;
«L2» high speed, attachment rotates to the left, the
illumination (12) lights brighter;
Carefully move the attachment along the surface being
treated.
After you finish using the unit, set the switch (9) to the
position «0», the illumination (12) will go out.
Remove the attachment (2-7) from the motor unit (8).
VT-2212_IM_70x130.indd 5 26.11.2018 11:34:52

Содержание

Похожие устройства

Скачать