Condtrol Neo X1-360 (1-2-127) [9/27] Condtrol neo x1 360 x2 360 condtrol neo x1 360 x2 360
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Condtrol Neo X1-360 (1-2-127) [9/27] Condtrol neo x1 360 x2 360 condtrol neo x1 360 x2 360

Condtrol NEO X1-360 [9/27] Condtrol neo x1 360 x2 360 condtrol neo x1 360 x2 360
16 17
user manual user manual
EN EN
CONDTROL NEO X1-360/X2-360 CONDTROL NEO X1-360/X2-360
CROSS
LINE LASER
CROSS
LINE LASER
CARE AND MAINTENANCE
Attention! The product is an accurate optical mechanic device and
requires careful handling. Check the accuracy before using.
To increase the operating time and avoid the risk of unintentional
blindness switch the laser on only when you are ready to make
measurements.
If operated near objects or air streams with different from the
environment temperature the laser line may tremble due to
heterogeneity of the atmosphere. The longer is the distance, the more
trembling can be observed
The width of the laser line increases with the increasing of the
operating distance. The layout should be made along the axis of the
laser line. For maximum accuracy, use the middle portion of the laser
line.
It should be noted that the shape of the laser line on the object’s
surface (e.g., walls, ceilings, etc.) depends on the curvature and tilt of
the surface relative to the laser plane.
Maintenance of the following recommendations will extend the life
of the device:
- Transport and carry the product only with locked compensator.
- Keep the product clean and protected from any bumps, dust and
dampness; do not allow getting moisture, dust or other dirt inside of
the product.
- In case if any moisture goes into the product, remove the batteries
and take it to the service center.
- Do not keep or use the device for a long time at high humidity
conditions.
- Keep the instrument clean and wipe it with a clean and soft cloth.
Mishandling of the following rules can cause electrolite leakage
from the batteries or other damages:
- Remove the batteries from the product if you do not use it for a long
time.
- Do not use different battery types with different charge levels.
- Do not leave discharged batteries in the product.
CHECK OF VERTICAL LINE
Use a plumb bob as a reference of a vertical line. Place the instrument
at distance of 1,5m from the plumb bob.
1. Unlock the compensator, switch on the vertical laser line and align it
with the low point of plumb bob.
2. If deviation between the laser line and the plumb bob line exceeds
±0.3 mm per 1m of the plumb bob length (for a 2.5m plumb bob
deviation shouldn’t exceed 0.75 mm) please contact service center.
3. Turn the instrument by 180° and align the vertical laser line with the
low point of plumb bob once again*.
* NEO X2-360 only.

Содержание

Похожие устройства

Скачать