Kenwood TK-2306 Инструкция по эксплуатации онлайн [11/18] 601739

chArging the BAttery pAck

ATTENTION: Always switch OFF a transceiver equipped with a

battery pack before inserting the transceiver into the charger.

1 Plug the AC adapter cable into

the jack located on the rear of the

charger.

2 Plug the AC adapter into an AC

outlet.

3 Slide a battery pack or a

transceiver equipped with a

battery pack into the charging

slot of the charger.

• Make sure the metal contacts of

the battery pack mate securely

with the charger terminals.

• The indicator lights red and

charging begins.

Charging slot

Indicator

4 When charging is completed, the indicator lights green.

Remove the battery pack or the transceiver from the

charging slot of the charger.

• It takes approximately 2 hours to charge the battery pack.

• When the charger will not be used for a long time, unplug the

AC adapter from the AC outlet.

Note:

◆ When the indicator blinks red, the battery pack is either defective or

the battery pack contacts are not properly mated with those of the

charger.

◆ The ambient temperature should be between 5°C and 40°C while

charging is in progress. Charging outside this range may not fully

charge the battery.

◆ The battery pack life is over when its operating time decreases even

though it is fully and correctly charged. Replace the battery pack.